I wanted to post a bit of information about how Holley Transferred the fuel from the Single Inlet Fuel Fill Banjo Fitting to both carb fuel bowls.
1) Fuel comes from the Fuel Pump/fuel filter thru a hose to the Banjo Fitting on the Primary Bowl of the Holley 4160 Carb. Pic #1 Post #310
2) There is a drilling in the fuel bowl close to the Banjo Fitting pointing towards the rear bowl. Pic #1 Post #310
3) There is a second drilling facing the Primary Bowl on the Secondary Bowl. Pic #1 Post #310
4) A aluminum tube with two raised sealing surfaces near the edge of the tube transferred the fuel between the bowls. Pic #2 Post #309
5) In order for the fuel to not leak past the aluminum tube ends a simple o-ring was installed over the tube end and the o-ring lubed up with a touch of vasoline and was inserted in one of the bowls drilled cavity. Pic #3 Post #309
6) A second o-ring using vasoline is installed on the tube and the into the other drilling in the other fuel bowl. It does not matter which one you install first. I work typically on the Primary Bowl components first so the secondary bowl gets installed at the last step.
Here are some pictures of both the old style O-ring transfer tube assy and the New style assy. Pic #4 & 5 Post #309
Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught
Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward.
Last edited by Tom Vaught; 03-09-2018 at 11:33 PM.
|