Quote:
Originally Posted by gtobird
Well I guess since yesterday was St. Patty's day the luck of the Irish continued. I found an old non-dual gate shifter I had in my pile of stuff to sell. Found a clip in there. It must have come off the cover for that shifter. Exactly the same as the dual gate clip.
|
Got mine fixed the same way you did yours. Just a tip for anyone else attempting this. As mentioned, the nut needs to be shaved down on the sides so it fits in the clip. The first time I did it, the nuts fit fine in the clips, but I couldn't get the clips to compress enough when I went to snap the cover plate in place. I then shaved the sides of the nuts down some more and squeezed each clip together with a pair of vice grips before tigthening each machine screw. That way I knew for certain there was enough material removed. Worked fine after that.
OJ