Quote:
Originally Posted by dataway
Oxy/Act brazing should work just fine if you can get the material clean enough. Also don't set any undercoating on fire.
Could be done on a 15amp circuit, lower settings, preheat the metal a bit, more passes. I use my little Lincoln MIG all the time plugged into a 15amp circuit as I move it around the vehicle. Has never popped the breaker .... I'm sure it would if I turned it all the way up.
|
Good answer, thank you.
__________________
1967 GTO, hard top, 400 Block, Butler Performance Build, EFI Holley Sniper, Tremec 5-Speed, Moser 373 Rear, 4 Wheel Disc Brakes
|