[Kenth]

Originally Posted by Jimbobeast

There is a small wire/lever (?) that goes from the pump piston lever to an area under a small cover (see photos). What does this do? Also, do I have it installed correctly?

Also, at the base of the vent tube in these photos is a triangular pressed-on bracket. Beneath the bracket is what appears to be a metering screw (like the idle mix screws). What does this do? I turned it in all the way and then backed out 2 full turns. I don't find this on my other carbs, but it is present in the photos from Unruhjohnny in a previous post in this thread. Very mysterious.

The last photo shows the cover installed.

This might help some.