Quote:
Originally Posted by BruceWilkie
Bill made a workpiece from cv1 work pieces last winter... not pretty but cost effective model... (hand carvin an expensive solid billet isnt very cost or time effective) It was then digitized . Jim and Bill verified locating points, got rid of ugly cosmetics etc., to insure it needs only routine work once cut on the cnc. They do have water provisions worked out for the billet if desired. I've seen the ports on the flowbench... I'll just verify that Jims posted numbers arent inflated. Bill is fanatic about verifying his bench accuracy when he sees an improvement.
Jim has the ability to create a fully water jacketed cast version... (I'd like to own that but demand and deposits would have to happen first). IMO doing so would limit it from the potential the billet could have.
|
So the initial ground work has been layed, Jim is just waiting for a customer to put down a deposit before he produces the first set?
Bryan