Quote:
Originally Posted by caddor38
Thanks for the recommendations. I see these pumps mostly have 6an ports. i assume i will need a 8an to 6an fitting? Will this impede fuel flow?
|
These pumps, holley blue, hp150, mallory etc do not have AN ports. They mostly have 3/8 NPT pipe thread ports, i never could figure out NPT nomenclature but 3/8 NPT is bigger than 1/2" and can easily accommodate a - 8AN fitting. Just install 3/8NPT to - 8AN fittings and run - 8An lines and there will be no restriction
Jon
__________________
'78 Macho T/A DKM#95, 460cid, SRP pistons, KRE 310 D ports,
3" pypes, Hooker 1 3/4" headers, hydraulic roller,
10" Continental, 3.42 gears
11.5 @117.5mph 3900lbs
([_|_] ##\|/##[_|_])