Quote:
Originally Posted by Jay S
There are applications where the 60919 is better, and in other places the RA4 CMC grind’s do better. Crane had a RA 4 grind is another version different than these others also that is ground noticeable different too.
If the compression is on the higher side, about 10:1 or just under, then use the SPC-8 or the Eddy cam. If the compression is a bit lower in the mid 9s the 60919 does not need Rhoads lifters and performs better.
|
Jay, I have one of those Crane cams, for use in a 455. How does it differ?
Jeff
__________________
1977 Black Trans Am 180 HP Auto, essentially base model T/A.
I'm the original owner, purchased May 7, 1977.
Shut it off
Shut it off
Buddy, I just shut your Prius down... 
|