Something you can do to make the process a bit easier is to take your old pinion bearing use a sanding drum on the inside of the race where it goes on the pinion use the slip fit bearing to get a good pattern on your new gears establish a shim dimension then press the new bearing and shim on for final install
during the slip fit bearing use you use the yoke and new outer pinion bearing omit the crush sleeve for now and tighten down the pinion nut to get a few inch pounds of turning force on pinion ( everything seated well)
__________________
If your not at the table you're on the menu
A man who falls for everything stands for nothing.
Last edited by Formulas; 03-28-2024 at 09:17 AM.
|