Victory!
Well, maybe against the odds I was able to get the broken extractor out. Used a $14 dremmel bit as shown in pics. yay!
Now the question is how to proceed. Was wondering if I can use a 1/4 bit in the hole? Bolt is 3/8 so not a lot of extra room in case I'm off center. But I get the feeling the bigger the hole the better?
Don't have a file with detachable handle unfortunately or I would try that first.
Thanks again for all your suggestions and moral support ha ha!
__________________
1969 Judge, 4-speed, CR/Parchment, Quasi-Survivor, #'s match - under restoration
|