Quote:
Originally Posted by grivera
I recently rebuilt an M6907 and hand-bent a line using a spring tube bender and aluminum thick-walled 3/8” tubing. At the pump output I used a 90 degrees not to inverted flare fitting.
|
That should read “a 90 degrees NPT to inverted flare fitting”
__________________
Will Rivera
'69 Firebird 400/461, 290+ E D-Ports, HR 230/236, 4l80E, 8.5 Rear, 3.55 gears
‘66 Lemans, 455, KRE D-Ports, TH350, 12 bolt 3.90 gears
'64 LeMans 400/461, #16 Heads, HR 230/236, TKO600, 9inch Rear, 3.89 gears (Traded)
'69 LeMans Vert, 350, #47 heads: Non-running project
|