[79 Phoenix]

Originally Posted by JSchmitz

I did it on my '64 by jacking the left rear of the body up. Ran the lines in through the rear wheel well. I installed two lines. One 1/2" and one 3/8". They are both stainless steel. The 3/8" line went in pretty well. It was easy to bend. The 1/2" was bad! B-Man has a good thread about this.

Thanks--I will try to find B Man's thread. As I state above, when I replaced body mounts the cages were rusted out and I cut holes in the trunk again to gain access--which would make a big mess. I would like to avoid if I can.. Then re-assembled using just nuts and lock washers. I would have to cut open trunk access to get to rear body mount nuts loosened...

I wonder if I cut trunk open again I could lift body enough to get this done? At this point with the rear body mount still tight (the rest loose) I can get body up about 3/4" which is not enough.