Quote:
Originally Posted by Stan Weiss
Sorry but I don't see the cam card posted.
When the motor is running I would interested to see how close that cranking compression calculator is. It uses 0.050" IVC plus 15 degrees. For a hydraulic cam I would want to use IVC @ 0.006"
Stan
|
me too, I'll find out soon
Quote:
Originally Posted by PunchT37
LOL. Those sound like Dairy Queen cams?  |
sure it does
[QUOTE=Jay S;6456924]I noticed too that this new combination is getting the new evolution comp lifters. Those have only been out less than a year. So have you even ran that big thumper cam? Do you know what it will be like driving a cam with 95* of overlap?
I have and I sure do.! same set up i ran for 5yrs / 15,000 miles. longest trip i took was 12hr 440miles damn near straight running ( had to stop for fuel a few times )
in the mountains of PA on a all day covered bridge tour with my daughters.
i had the regular lifters from comp but had to swap out for these because they had the same specs i did not need to change anything else.
Quote:
Originally Posted by tom s
3/8 pushrod over kill for hyd roller IMO.Tom
|
of course it is.....