View Single Post
  #1  
Old 09-06-2022, 09:51 AM
stich's Avatar
stich stich is offline
Member
 
Join Date: Dec 2016
Location: Pioneer CA
Posts: 64
Default No Hot Start With Sniper System

I got the car started and runs really strong upon start up but after it warms up, it refuses to restart. I've got the sniper system with an MSD dist. and Blaster coil all on a bit pumped up 455. It gives a tiny "wanna" start while first cranking but then nothing. I can hear the fuel pump run for 5 seconds when I turn on the key and the gauge reads 60 lbs of pressure at the intake of the Sniper. I've tried advancing the dist 10 degrees both ways while cranking. Still nothing. After a couple hours, she starts up fine again. I'm baffled and have to admit, I know absolutely nothing about the electronical readings on the Sniper computer screen. I'm about ready to take it to a tune shop but there isn't one close enough to me to drive to. I've got around 150 miles on it so far. Suggestions?

__________________
www.recovery-shop.com
My upholstery shop