Steve Grebeck was killed in march 2002. He welded the EFI bungs on my Warrior Intake about 4 years earlier so that would mean my EFI project for a Pontiac started about 1998.
Now I intake sat for several years on the shelf due to Grebeck's death then I had a fabrication shop in Livonia finish the intake and do the upper plenum design and fabrication.
I used years ago the Holley High Ram intake plenum top piece (with the carb mounting portion of the top machined off) and a custom Warrior intake plenum port pattern (Dominator) plate welded to the area machined off.
I also used a 105mm Throttle Body upper Plenum vs the 95mm plenum top (as I already had a 105mm Holley Throttle Body). A fun project, but $$$$.
Mark at Luhn Performance apparently has several OFFY intakes either machined or mostly machined.
Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught
Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward.
|