[Dave from England]

Thank for all your help guys,
Just about got things worked out as how the top is installed.Hammered the short piece of steel that slides through the tunnel was all but shot couldnt find any section that was anywere near the original so I bought a length of flat aluminum bar half inch x three eighths cut it to length cut the ends to suit the original pattern clamped it to the cross rail marked the holes the drill & taped them and the jobs as good as new wont ever rust either.THe upholsterer came down & we made a start on fitting the top & hope to finish it off tomorrow.HAS ANYONE ANT TIPS AS TO HOW TO KEEP THE TOP TIGHT AROUND THE REAR QUARTER AREA.

Thanks
Dave from England