Quote:
Originally Posted by 81TTA
Thanks for the pictures of the manifold ports. Looks like some smoothing was done after the flanges were reattached?
I'm not sure if the Torker II came in versions without the exhaust crossover. It appears from one of your pictures that it's been milled off? I think it makes life a lot easier when the flange only needs to match up to the runners instead of trying to match up to the runners *and* the exhaust crossover.
Anyway, that manifold is sweet. Very nice work!
|
All T2's come with ex crossover. You can eliminate it. you could also block exhaust (fill) and plumb the heat crossover for water if you really want/need heat in your manifold. If it dont clear the valley tray shrink it. Its not terribly difficult to cut the entire heated section off a t1, performer, rpm, t2, HSD etc.. Wouldnt be hard to make a new manifold heater with aluminum tubing if you really felt you had to have one.
The harder part is what Dave said ^^^^!!!