Quote:
Originally Posted by goatcheese
I called autozone, napa, o'reilly's, advance, and pepboys and not only do none of them have them but they cant get them. I looked on ebay and didn't find them but did find a complete engine set with the head gaskets! The hunt was over and I could focus on other things. I check my ebay inbox and had a message regarding my order. They were informing me that there was a mistake with their listing and that the Victor's were not available but, the felpro's were... Back to my dilemma. Should I order custom copper gaskets for $100 each or SCE's 4.125" bore sized ones compared to the felpro 4.3". The pontiac 350 has a bore of 3.8". What do y'all think?
|
Look at the sponsors for this site. Many of the engine builders can get them. They might run some coin, but worth it. I don't under stand why they stopped making gaskets for 326/350. They are GREAT engines and make decent power for cheap. I have a 326 in a 4200lb wagon and you would swear it is a 400.
Here is one,.
http://www.ebay.com/itm/One-1968-197...d33d73&vxp=mtr
This one shows the correct gasket...
http://www.ebay.com/itm/Victor-FS340...sories&vxp=mtr