[Tech @ BG]

Originally Posted by Mr_GTO

Not just that but how about testing each piece that goes out the door to make sure it doesn't have to be returned. I can't imagine that BG sells enough Pontiac 6Shooters(At $2500 a pop) to say that they can't check and test each and every one.

The only intakes with issues are the early run which were machined by an outside vendor for us to which we supplied an engine and they were supposed to be checking for us. Until the problem was brought to our attention we were not aware of it. Once it came to light, as already mentioned we moved this process in house and have not had fitment issues since.WE are also checking the intakes now to make sure they fit and since moving this in house have not had any machining related fitment complaints.You guys are hashing over and over issues that have already been addressed and corrected and that we have stated in THIS thread have corrected. We have had a couple of calls since stating they dont fit and in both cases it was determined they were trying to use the pre 64 valley pan that doesn't have the slots in the runner area. We also had a guy send one of the old ones back[not from this forum] that he said would not fit and we bolted it directly onto the engine with no problem. Keep in mind that if the heads or intake has been cut the fit would be no different than anybody elses intake.