OPH I know you have had to played with this. Just got my 12 bolt back form having ends welded, backing plates opened up, etc. Went to mock up the rear discs and teh drivers side has been tweaked. One side of the caliper is 0.2" further away then the other side. Been trying to use a cresent wrench to bend it but it seems to cock it at an angle . Seems like the base of the bracket needs some bend and its too stout there. Also bending one side separate may not keep the spacing perfect.
Any suggestions? I figure being a floating caliper it can have a little mis match but I remeber having one caliper squeal in reverse because the caliper was tweaked.
__________________
Skip Fix
1978 Trans Am original owner 10.99 @ 124 pump gas 455 E heads, NO Bird ever!
1981 Black SE Trans Am stockish 6X 400ci, turbo 301 on a stand
1965 GTO 4 barrel 3 speed project
2004 GTO Pulse Red stock motor computer tune 13.43@103.4
1964 Impala SS 409/470ci 600 HP stroker project
1979 Camaro IAII Edelbrock head 500" 695 HP 10.33@132 3595lbs
|