Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: Schurkey
Forum: Pontiac - Street 05-19-2024, 10:14 PM
Replies: 6
Views: 207
Posted By Schurkey
Pop the speedo cable out of the speedo, see if...

Pop the speedo cable out of the speedo, see if the noise goes away or at least changes.
Forum: Pontiac - Street 05-16-2024, 12:55 PM
Replies: 16
Views: 296
Posted By Schurkey
Virtually every car with (front) disc brakes, or...

Virtually every car with (front) disc brakes, or 4-wheel discs has a power booster.

Disc brakes have very little self-energizing action, and what little they have reduces as the pads wear.
...
Forum: Pontiac - Street 05-14-2024, 01:13 PM
Replies: 32
Views: 740
Posted By Schurkey
You are WAY over-thinking this. "Priming"...

You are WAY over-thinking this.

"Priming" involves removing air from the oiling system--oil pump, filter, the larger oil galleries. It is NOT intended to spray oil over the fenders from the...
Forum: Pontiac - Street 05-14-2024, 02:11 AM
Replies: 8
Views: 318
Posted By Schurkey
No, it does not make sense. Describe what...

No, it does not make sense.

Describe what the steering wheel does.


What about thickness variation?
Forum: Pontiac - Street 05-13-2024, 11:21 PM
Replies: 10
Views: 356
Posted By Schurkey
Any engine with non-adjustable rockers does not...

Any engine with non-adjustable rockers does not change geometry with pushrod length. Pushrod length changes affect lifter plunger preload only.

Pontiac with "bottleneck" studs and nuts torqued to...
Forum: Pontiac - Street 05-13-2024, 11:02 PM
Replies: 8
Views: 318
Posted By Schurkey
WHAT DO YOU MEAN "feeling braking in my steering...

WHAT DO YOU MEAN "feeling braking in my steering wheel"?

What does the steering wheel DO? Shake? If so, most-likely cause is warped rotor(s), but pull the handle on the park brake, gradually...
Forum: Pontiac - Street 05-12-2024, 02:01 AM
Replies: 17
Views: 709
Posted By Schurkey
Acetylene or Propane plus Oxygen is much hotter,...

Acetylene or Propane plus Oxygen is much hotter, works WAY better.

As said--heat the plug, not the casting.


Tried that once. Enormously too much oil along with the refrigerant. Messy as...
Forum: Pontiac - Street 05-12-2024, 01:50 AM
Replies: 36
Views: 1,170
Posted By Schurkey
Dinosaurs all died 65 million years ago. Ten...

Dinosaurs all died 65 million years ago. Ten years on processed oil doesn't seem that much by comparison.
Forum: Pontiac - Street 05-11-2024, 02:23 PM
Replies: 32
Views: 1,831
Posted By Schurkey
Not what I'd expect. I'm not in a position to...

Not what I'd expect. I'm not in a position to challenge B&M, but I'd have expected 170--200 in the pan, not in the cooler return-tube. Many modern cars have transmission temperature sensors on the...
Forum: Pontiac - Street 05-06-2024, 01:24 AM
Replies: 10
Views: 557
Posted By Schurkey
.031625 X 1.5 = .0474 But with .120 plunger...

.031625 X 1.5 = .0474

But with .120 plunger travel, it won't matter.
Forum: Pontiac - Street 05-05-2024, 03:17 PM
Replies: 10
Views: 557
Posted By Schurkey
I don't think it's anywhere near as critical as...

I don't think it's anywhere near as critical as some folks have made it out to be.

How much lifter plunger travel do your lifters have? I've seen OEM lifters with more than a quarter-inch of...
Forum: Pontiac - Street 05-05-2024, 04:01 AM
Replies: 10
Views: 557
Posted By Schurkey
That's .031 at the adjuster nut. Not .031 at the...

That's .031 at the adjuster nut. Not .031 at the lifter plunger where it matters. You're not taking rocker ratio into account. The lifter plunger is being depressed more than .031.


Yes, IF...
Forum: Pontiac - Street 05-05-2024, 01:57 AM
Replies: 20
Views: 900
Posted By Schurkey
3 psi is probably insufficient. The gaskets...

3 psi is probably insufficient.

The gaskets aren't soggy because the fuel level is too low.

What you have going for you is that there's three needles 'n' seats instead of one. More-or-less...
Forum: Pontiac - Street 05-02-2024, 04:24 PM
Replies: 8
Views: 573
Posted By Schurkey
1. It would help enormously if you'd crop and...

1. It would help enormously if you'd crop and resize pictures so the detail that mattered was more prominent.

2. Given the leaded fuel, and the additives, I don't think anyone can say for sure...
Forum: Pontiac - Street 05-02-2024, 04:12 PM
Replies: 20
Views: 900
Posted By Schurkey
I'd expect that would lower volume, but not...

I'd expect that would lower volume, but not pressure. May be so slight that you'd never notice.

Pressure is set via the internal spring.
Forum: Pontiac - Street 04-30-2024, 07:01 PM
Replies: 10
Views: 601
Posted By Schurkey
THANK YOU. Not many folks recognize the...

THANK YOU. Not many folks recognize the difference between Torque/Angle and TTY.

I paint a stripe down the shank of torque/angle bolts. When I remove them later, if the paint stripe is twisted,...
Forum: Pontiac - Street 04-24-2024, 06:52 PM
Replies: 58
Views: 2,568
Posted By Schurkey
Oldsmobile restricted their heater supply, so did...

Oldsmobile restricted their heater supply, so did Chevrolet.

No promises on Buick and Cadillac, but my guess is that all GM divisions restricted the heater core flow somehow. Either a small hole...
Forum: Pontiac - Street 04-24-2024, 11:40 AM
Replies: 11
Views: 575
Posted By Schurkey
Any transmission I open up, is going to be done...

Any transmission I open up, is going to be done with the aid of a ATSG "Techtran" manual, along with whatever D-I-Y/consumer-oriented book(s) I can lay my hands on.

The ATSG manuals are not...
Forum: Pontiac - Street 04-22-2024, 01:49 AM
Replies: 43
Views: 2,531
Posted By Schurkey
Yeah, GM kept that a complete secret. Who would...

Yeah, GM kept that a complete secret. Who would have ever guessed that there was a resistor bypass wire? Certainly not an outside company designing products to be used on GM products. (Moreover,...
Forum: Pontiac - Street 04-19-2024, 08:01 PM
Replies: 43
Views: 2,531
Posted By Schurkey
Hint: Mallory pushes a protection device that...

Hint: Mallory pushes a protection device that costs as much as the Unilite module.
https://www.summitracing.com/parts/maa-29371

I say the "protection" should have been built-into the module at...
Forum: Pontiac - Street 04-19-2024, 04:38 PM
Replies: 43
Views: 2,531
Posted By Schurkey
I haven't dicked with points for thirty years. I...

I haven't dicked with points for thirty years. I make sure that every vehicle I own has an electronic ignition; and there's none better than the good ol' GM Delco HEI in good usable condition. The...
Forum: Pontiac - Street 04-19-2024, 04:33 PM
Replies: 6
Views: 538
Posted By Schurkey
Totally depends on the geometry of the headers. ...

Totally depends on the geometry of the headers.

First Guess: Not likely due to the width of the trans bellhousing where the torque converter dust pan attaches.
Forum: Pontiac - Street 04-19-2024, 01:06 PM
Replies: 16
Views: 1,169
Posted By Schurkey
Could be.

Could be.
Forum: Pontiac - Street 04-19-2024, 09:58 AM
Replies: 16
Views: 1,169
Posted By Schurkey
Holdoff valve, safety switch, and proportioning...

Holdoff valve, safety switch, and proportioning valve moved into the Combination valve, which also became the distribution block.
Forum: Pontiac - Street 04-16-2024, 03:46 PM
Replies: 32
Views: 1,946
Posted By Schurkey
Photo shows "Made in USA". Good score. Is there...

Photo shows "Made in USA". Good score. Is there an anti-drainback valve, and if so, what color is it--black or orange? (or something else.)

Big discussion on another forum about...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 02:14 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017