Showing results 1 to 25 of 49
Search took 0.01 seconds.
Search: Posts Made By: p2architect
Forum: 61-63 Tempest & LeMans TECH 10-31-2014, 05:27 PM
Replies: 4
Views: 224
Posted By p2architect
Rear trunk emblem install trick

The 326 Lemans emblem on the trunk lid has a small hole to access the emblem studs.
Who invented a tool or trick to install the nuts on those studs? Because my fingers don't fit into holes that...
Forum: 61-63 Tempest & LeMans TECH 05-26-2014, 05:09 PM
Replies: 6
Views: 273
Posted By p2architect
That car is still grey. Just with better paint. ...

That car is still grey. Just with better paint. Still has the sidepipes. Still fast.
Forum: 61-63 Tempest & LeMans TECH 01-26-2013, 05:06 PM
Replies: 56
Views: 2,674
Posted By p2architect
No not good. But it sure looked good on the...

No not good. But it sure looked good on the block. Seller was not smiling. My 63 was a bit dismayed as well. There, there.
Forum: 61-63 Tempest & LeMans TECH 01-22-2012, 03:03 PM
Replies: 13
Views: 544
Posted By p2architect
I sent mine to Helena Montana. dipitnow.com. ...

I sent mine to Helena Montana. dipitnow.com. They did a fantastic job to bring back to life. Give them a call. They do very good work. And the price was right.
Forum: 61-63 Tempest & LeMans TECH 11-09-2011, 01:43 PM
Replies: 3
Views: 444
Posted By p2architect
Keith, Thank you for the questions. It just...

Keith,

Thank you for the questions. It just started with this problem. And I have not done anything yet. I will pull my book out and take a look at an adjustment in the linkage. Good suggestion...
Forum: 61-63 Tempest & LeMans TECH 11-08-2011, 08:25 PM
Replies: 3
Views: 444
Posted By p2architect
63 transaxle kick out

I am having a problem with the transaxle kicking-out of gear. The car has the Automatic transmission with on floor shifter with parking brake. When parked transaxle is not engaging when shifted...
Forum: 61-63 Tempest & LeMans TECH 03-07-2011, 09:36 PM
Replies: 2
Views: 216
Posted By p2architect
63 Rocker trim clips

I am down to a few last details and the car will be complete. Who has the solution to replace the rocker panel stainless steel trim clips. Where can I get some (10) clips and what is the part...
Forum: 61-63 Tempest & LeMans TECH 12-12-2010, 05:38 PM
Replies: 7
Views: 333
Posted By p2architect
Lessons learned. Take your time when you take...

Lessons learned. Take your time when you take this wiring system apart. Take many photos. Make your own diagram or copy of the Pontiac Manual diagram and note any differences in your car. Not all...
Forum: 61-63 Tempest & LeMans TECH 12-09-2010, 09:24 PM
Replies: 6
Views: 233
Posted By p2architect
Duramix is MUCH better choice. TCP Global sells...

Duramix is MUCH better choice. TCP Global sells $39. Got from Amazon for $32 including shipping. Thank you.
Nice to have friends with grease under their finger nails.
Forum: 61-63 Tempest & LeMans TECH 12-09-2010, 02:33 AM
Replies: 6
Views: 233
Posted By p2architect
I think I will get a tube of this and make a...

I think I will get a tube of this and make a test. http://www.sikaconstruction.com/tds-cpd-SikaBoom-us.pdf
Forum: 61-63 Tempest & LeMans TECH 12-09-2010, 02:21 AM
Replies: 6
Views: 233
Posted By p2architect
It seemed to me that when I scraped out the...

It seemed to me that when I scraped out the original...it was more of an expanding foam type of adhesive. I am going to check 3m and Sitka...maybe I will get lucky. But adhering in a black piece or...
Forum: 61-63 Tempest & LeMans TECH 12-07-2010, 05:09 PM
Replies: 6
Views: 233
Posted By p2architect
63 hood brace

Any product or ahesive to attach under hood brace to hood. Original. Seems llike quarter. Inch thick black. What to use now?
Forum: 61-63 Tempest & LeMans TECH 09-29-2010, 07:17 AM
Replies: 3
Views: 289
Posted By p2architect
63 Parking Lights Wiring

The next problem to resolve. The front parking/blinkers do not work. These lights are supplied as far as I can tell by three wires. Power to blinkers by one light blue and one dark blue wire...
Forum: 61-63 Tempest & LeMans TECH 09-26-2010, 11:50 AM
Replies: 5
Views: 317
Posted By p2architect
Thank you. I took off the strike plate. Then...

Thank you. I took off the strike plate. Then adjusted the door in all directions so it was straight and closed well. Then I put the strike plate back on. Interesting note, the further out the...
Forum: 61-63 Tempest & LeMans TECH 09-25-2010, 03:58 PM
Replies: 5
Views: 317
Posted By p2architect
63 Door Staright

So I pulled the doors off to restore. Now I have them back on - sort of. I am having a hard time with alignment. I can get the door horizontally correct. But the problem is when I close the door...
Forum: 61-63 Tempest & LeMans TECH 09-07-2010, 07:20 AM
Replies: 5
Views: 492
Posted By p2architect
Transaxle Fluid

Transalxe Fluid is what type. ATF, 80w gear oil, 95w gear oil, other.
Who is using what?
Forum: 61-63 Tempest & LeMans TECH 08-11-2010, 05:40 PM
Replies: 5
Views: 348
Posted By p2architect
Thank you for posting a photo. Seems previous...

Thank you for posting a photo. Seems previous part was not the original piece. Sometimes with these cars - need to be creative. Ken at East West hooked me up with correct part. Again, thank you...
Forum: 61-63 Tempest & LeMans TECH 08-10-2010, 08:26 PM
Replies: 5
Views: 348
Posted By p2architect
Sorry photo would not load. Too big of a file. ...

Sorry photo would not load. Too big of a file. I think the part was about 3/8" in diameter and about 3" long with a bend in it. This is the part the the latch catches to hold the lid down. Again...
Forum: 61-63 Tempest & LeMans TECH 08-10-2010, 08:20 PM
Replies: 5
Views: 348
Posted By p2architect
63 Trunk Latch

The attached photo is the "box" where the trunk lid latch attaches. Inside this "box" is a part that the latch connects to. As you can see - I am missing that part. I lost it in the renovation...
Forum: 61-63 Tempest & LeMans TECH 07-10-2010, 11:11 PM
Replies: 2
Views: 117
Posted By p2architect
Thank you. I did not think it was right.... I...

Thank you. I did not think it was right.... I got one from Ken and sometimes he pulls the wrong part off the shelf. Now to the search for another (correct one) .... thanks again. Or maybe I...
Forum: 61-63 Tempest & LeMans TECH 07-10-2010, 10:10 PM
Replies: 2
Views: 117
Posted By p2architect
63 nose emblem part no

Is this the correct part no. for the 63 Lemans nose emblem?
544965. 5 3/4" long 2 1/4" wide flat, no curve
thank you for reply
Forum: 61-63 Tempest & LeMans TECH 06-23-2010, 01:31 PM
Replies: 2
Views: 257
Posted By p2architect
Need to remove the u shaped bracket under the...

Need to remove the u shaped bracket under the dash holding the column up. Need to loosen the set screw inside the engine compartment located along the steering column. Next to the firewall between...
Forum: 61-63 Tempest & LeMans TECH 06-05-2010, 02:58 PM
Replies: 3
Views: 330
Posted By p2architect
Thank you, kindly.

Thank you, kindly.
Forum: 61-63 Tempest & LeMans TECH 06-04-2010, 07:08 PM
Replies: 3
Views: 330
Posted By p2architect
63 Gunsight measurements

I need a few measurements for the location of the gun sights on top of the fender of the 63 Lemans. The holes have been welded and bondo. I am putting the top of the fender spears (gun sights) back...
Forum: 61-63 Tempest & LeMans TECH 05-14-2010, 11:23 AM
Replies: 32
Views: 809
Posted By p2architect
If you do part it out. I will take those bumper...

If you do part it out. I will take those bumper supports. And that steering wheel is a rare upgrade. As is that remote mirror on the fender.

Check for rust in the trunk. Both sides. It's...
Showing results 1 to 25 of 49

 
Forum Jump

All times are GMT -4. The time now is 04:48 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017