Forum: 67-92 Firebirds & Trans Ams FOR SALE
04-12-2011, 11:23 PM
|
Replies: 4
Views: 494
|
Forum: 67-92 Firebirds & Trans Ams FOR SALE
04-02-2011, 06:43 PM
|
Replies: 4
Views: 494
1976 Trans Am 455 4speed project
Solid builder, needs a quarter panel and complete restoration. Runs and drives but not roadworthy. Would like 4000.00, please see Colorado Springs craigslist for more info. Thanks!
|
Forum: 74-76 Firebird & TA TECH
11-19-2007, 11:17 PM
|
Replies: 1
Views: 299
oem fuel pump number
Help! My car is stored 60 miles away and last week when I went down to start it and let it run it was blowing gas out of the fuel pump. I would like to get a new AC Delco replacement but am unsure of...
|
Forum: Suspension TECH
06-05-2007, 02:11 AM
|
Replies: 12
Views: 376
Anythings possible but worth it? You could use...
Anythings possible but worth it? You could use your race installer cups on a homemade mandrel with a serious angle on your cutter and probably pull it off. Pep boys here will turn drums for 6-10...
|
Forum: 74-76 Firebird & TA TECH
06-05-2007, 01:45 AM
|
Replies: 3
Views: 611
|
Forum: 74-76 Firebird & TA TECH
06-04-2007, 05:16 PM
|
Replies: 1
Views: 354
I can't believe no response yet. I looked all...
I can't believe no response yet. I looked all over for a repro' of this and could not find any so I "liberate" them from any Firebirds I find in the junkyards. About half are already broken or very...
|
Forum: 74-76 Firebird & TA TECH
12-15-2006, 09:30 PM
|
Replies: 1
Views: 373
|
Forum: 74-76 Firebird & TA TECH
12-07-2006, 12:34 AM
|
Replies: 1
Views: 373
1976 T/A air cleaner help
Hello! I need help with the vacuum hose routing on my 1976 T/A 455 air cleaner. The temp. sensor sticking off the back is shown on the core support tag but the two sensors under the lid are not. Are...
|
Forum: 74-76 Firebird & TA TECH
08-15-2006, 05:54 PM
|
Replies: 6
Views: 226
|
Forum: 74-76 Firebird & TA TECH
08-14-2006, 12:06 AM
|
Replies: 6
Views: 226
|
Forum: The Body Shop TECH
07-07-2006, 12:14 AM
|
Replies: 6
Views: 247
whats a good parts washer solvent?
Hello! I'm looking for a good cleaning solvent for my 5 gal. parts washer that actually works. Something for wheel bearings and engine parts. Oh yeah, it has to be non-flammible because I have a gas...
|
Forum: Suspension TECH
02-18-2006, 10:53 PM
|
Replies: 4
Views: 393
|
Forum: Suspension TECH
02-18-2006, 10:43 PM
|
Replies: 13
Views: 505
They used to sell a little master cly. bleeding...
They used to sell a little master cly. bleeding kit, it was a couple of plastic fittings with stepped threads to fit different sizes of ports on one side and a hose nipple on the other and a little...
|
Forum: Suspension TECH
02-15-2006, 12:57 AM
|
Replies: 2
Views: 277
Part store "jobbers" can get stuff from rare...
Part store "jobbers" can get stuff from rare parts, they don't sell to guys like you and me, pick up a Hemmings, (brown cover, size of a small phone-book), should be a few sources in there.
|
Forum: Suspension TECH
02-15-2006, 12:51 AM
|
Replies: 6
Views: 496
OK, here we go:
steering- 2 outer tie rod ends,...
OK, here we go:
steering- 2 outer tie rod ends, 2 inner tie rods, 2 adjusting sleeves, centerlink and idler arm, maybe even steering column coupler
suspension- 2 upper and lower ball joints, upper...
|
Forum: 74-76 Firebird & TA TECH
02-05-2006, 12:30 AM
|
Replies: 9
Views: 359
|
Forum: Suspension TECH
02-02-2006, 03:10 AM
|
Replies: 2
Views: 361
|
Forum: Suspension TECH
02-02-2006, 02:51 AM
|
Replies: 9
Views: 391
What kind of animal are we working on? Is it...
What kind of animal are we working on? Is it possible your new master is for a 4 wheel drum brake car sold to you by mistake? They have a check valve on the port that goes to the front to keep a...
|
Forum: 70-72 GTO Tempest & LeMans TECH
02-01-2006, 01:05 AM
|
Replies: 3
Views: 213
You can find pipe thread taps at Home Depot or...
You can find pipe thread taps at Home Depot or Sears. It's nice to chase the threads on anything you're putting back together so it goes together nice. Just remember that pipe threads are tapered on...
|
Forum: 74-76 Firebird & TA TECH
01-30-2006, 10:25 PM
|
Replies: 2
Views: 375
I need some of this paint also. I guess they...
I need some of this paint also. I guess they refer to it as a color for Olds 455's. Starcaster blue? Looks right compared to the old paint on my '76 T/A Pontiac 455. I'd hate to pucker up for the 29...
|
Forum: Suspension TECH
01-30-2006, 10:13 PM
|
Replies: 46
Views: 1,632
I like Raybestos in the red box, I think...
I like Raybestos in the red box, I think RPG-D52?. I don't like metallics because they can sometimes be hard on rotors and they generate so much heat. On some applications you don't have a choice,...
|
Forum: 74-76 Firebird & TA TECH
01-28-2006, 01:07 AM
|
Replies: 4
Views: 366
|
Forum: Pontiac - Street
01-27-2006, 10:58 PM
|
Replies: 12
Views: 566
You'll never get all the oil out of them, just...
You'll never get all the oil out of them, just plan on drip-pans and cardboard wrapped in trash bags to catch it. It takes very little oil to make a big spot on concrete, one whole quart and you'll...
|
Forum: 74-76 Firebird & TA TECH
01-27-2006, 03:26 AM
|
Replies: 4
Views: 366
stuck distributer
Hello, anyone have any ideas on getting the distributer out of my 455? The previous owner let it sit outside for a couple of years and water drained down from the shaker (missing it's 1/2" drain...
|
Forum: Suspension TECH
01-27-2006, 03:09 AM
|
Replies: 46
Views: 1,632
Hello '71 bird 400, just some ideas, when you...
Hello '71 bird 400, just some ideas, when you change pads rough up your rotors a little, a sanding disc on a drill works well. I would not use semi-met's on this car because they generate more heat...
|