Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 9 1 23 Last »
Showing results 1 to 25 of 208
Search took 0.02 seconds. Search: Posts Made By: caddor38
Forum: Pontiac - Street 02-09-2024, 07:47 PM
Replies: 17
Views: 614
Posted By caddor38
Oh, okay, i will give that a shot. Big thanks!

Oh, okay, i will give that a shot. Big thanks!
Forum: Pontiac - Street 02-09-2024, 07:00 PM
Replies: 17
Views: 614
Posted By caddor38
transmission leak at driveshaft seal

Guys I have looked this up on a few forums, however I am not sure if this is the same problem. I have transmission leak around the outer seal of my th400 transmission. The leak is not where the...
Forum: Pontiac - Street 12-02-2023, 06:25 PM
Replies: 19
Views: 1,098
Posted By caddor38
Okay guys, I put a heat plate between the carb...

Okay guys, I put a heat plate between the carb and the intake and problem still occurs. Engine temp was 215.. Just shuts off. I am able to crank it
as long as i hold accelerator to floor.
Forum: Suspension TECH 11-10-2023, 03:52 PM
Replies: 4
Views: 642
Posted By caddor38
Just finished the job and the directions worked...

Just finished the job and the directions worked perfectly! Big thanks again
Forum: Suspension TECH 11-07-2023, 06:13 PM
Replies: 4
Views: 642
Posted By caddor38
Big thanks, just tested the method and looks easy...

Big thanks, just tested the method and looks easy enough. Once the shock arrive i will give it a try.
Forum: Suspension TECH 11-07-2023, 03:40 PM
Replies: 4
Views: 642
Posted By caddor38
Removing and Replacing Comp Engineering coil over drag shocks

I have a 71 trans am that has a 4 link suspension in the back with Competition coil over drag shocks. The car has been sitting since 2004 and noticed one of the rear shocks is bad.
I have never...
Forum: Pontiac - Street 10-11-2023, 11:52 AM
Replies: 19
Views: 1,098
Posted By caddor38
Hey guys, thanks for all your suggestions. I...

Hey guys, thanks for all your suggestions. I decided to get a cool carb technologies plate to begin with. I have significant hood clearance issues so the 1/4" plate was the most elevation I could...
Forum: Pontiac - Race 10-02-2023, 09:37 AM
Replies: 14
Views: 939
Posted By caddor38
Sounds good folks, I will mark a new line in my...

Sounds good folks, I will mark a new line in my new dipstick.
Forum: Pontiac - Race 10-01-2023, 01:36 PM
Replies: 14
Views: 939
Posted By caddor38
I usually fill it towhere the oil sits right...

I usually fill it towhere the oil sits right between the add and full line and i think it would take 8.5 qts to meet that level. I am pretty sure the dipstick is the standard length. Just not...
Forum: Pontiac - Race 09-30-2023, 06:03 PM
Replies: 14
Views: 939
Posted By caddor38
Maybe I confused this. I have now put 7.5 quarts...

Maybe I confused this. I have now put 7.5 quarts of oil in the engine. The oil is just now touching the Add oil line on the dipstick. The dipstick is 18" from long measuring from the end to where...
Forum: Pontiac - Race 09-30-2023, 03:44 PM
Replies: 14
Views: 939
Posted By caddor38
Another oil capacity question

Hey guys, just doing my first oil change since engine build and I have a question about oil capacity. I have a Milodin 7 qt oil pan on my Pontiac stroked 455. I have read you put in 7 quarts ...
Forum: Pontiac - Street 09-23-2023, 10:46 PM
Replies: 19
Views: 1,098
Posted By caddor38
i addd a quick picture of the fuel line routing

i addd a quick picture of the fuel line routing
Forum: Pontiac - Street 09-23-2023, 10:40 PM
Replies: 19
Views: 1,098
Posted By caddor38
Guys, thanks for all the responses. I have...

Guys, thanks for all the responses. I have experienced vapor lock before and this did not seem to be vapor lock based on my past experience., but could be? The car was running around 210 degs. The...
Forum: Pontiac - Race 09-23-2023, 05:38 PM
Replies: 3
Views: 375
Posted By caddor38
Thanks for the response I will look into your...

Thanks for the response I will look into your comments and make changes.
Forum: Pontiac - Street 09-23-2023, 05:34 PM
Replies: 19
Views: 1,098
Posted By caddor38
Car shut off during U turn

Hey guys...I have another question that I was hoping to get some recommendations.

I recently finished my 71 firebird to Trans am build. I have test driven the cars 4 or 5 times and even took it...
Forum: Pontiac - Race 09-19-2023, 03:03 PM
Replies: 3
Views: 375
Posted By caddor38
Oil blow back

Hey guys, I have taken my new motor out on a few test drives and I have an issue that you guys can maybe help with. I have some aluminum valve covers with a couple of holes drilled for valve...
Forum: 67-81 Firebird & TA Parts FOR SALE 08-12-2023, 05:21 PM
Replies: 5
Views: 590
Posted By caddor38
Sold everything except the Grills

Sold everything except the Grills
Forum: 67-81 Firebird & TA Parts FOR SALE 08-02-2023, 04:42 PM
Replies: 0
Views: 126
Posted By caddor38
Hood Mounting Rales and mounting hardware

Hey guys, I have some hood mounting rails and push pin mounts that I was going to use on my 71 firebird with a fiberglass hood and decided to go another direction. Included is the folowing:
Quick...
Forum: Pontiac - Street 07-24-2023, 03:36 PM
Replies: 9
Views: 523
Posted By caddor38
Follow up to brake line issues

Okay guys, after about two weeks of cursing it appears the brake line leak issues between the master cylinder and the proportioning valve have been resolved. Thanks to you guys I purchased some of...
Forum: Pontiac - Street 07-17-2023, 09:11 PM
Replies: 9
Views: 523
Posted By caddor38
Yeah pre-bent steel? The line seats look okay...

Yeah pre-bent steel? The line seats look okay but the holes are little larger in diameter than my original master cylinder that didnt leak. I ordered 1/4 cone pieces as mentioned in my post and...
Forum: Pontiac - Street 07-17-2023, 08:53 PM
Replies: 9
Views: 523
Posted By caddor38
Hey guys thanks for your response. Yeah i just...

Hey guys thanks for your response. Yeah i just ordered the 1/4” copper flares because the lines are slightly bigger than the 3/16. Its the lines from the master cylinder to the proportioning valve?...
Forum: Pontiac - Street 07-17-2023, 06:26 PM
Replies: 9
Views: 523
Posted By caddor38
Brake Line Help, Master Cylinder to Proportioning Valve

Guys,
I am having a heck of a time attempting to get my brake lines sealed at the master cylinder. I was wondering if any of you have encountered the same issue? The two brake line connections at...
Forum: 67-81 Firebird & TA Parts FOR SALE 06-30-2023, 03:59 PM
Replies: 5
Views: 590
Posted By caddor38
Hey sorry, i just noticed you dont use paypal...

Hey sorry, i just noticed you dont use paypal and thats fine. Can you email me at caddor38@yahoo.com and i will send you my address. Im located in orlando.

Thanks
Chris
Forum: 67-81 Firebird & TA Parts FOR SALE 06-30-2023, 03:41 PM
Replies: 5
Views: 590
Posted By caddor38
Here are the details on the Front spoiler. Seems...

Here are the details on the Front spoiler. Seems to be a plastic but bendable… so not sure exactly what its mad of. https://www.summitracing.com/parts/OER-F15214.

My paypal is caddor38@yahoo.com...
Forum: 67-81 Firebird & TA Parts FOR SALE 06-30-2023, 01:08 PM
Replies: 5
Views: 590
Posted By caddor38
FIrebird Transam Misc Parts for sale

Hi folks, winding down my restoration and have some parts I either bought by mistake or have left over.

1. Shaker Scoop 70-76. I intended to attach this scoop to the hood so its just the...
Showing results 1 to 25 of 208
Page 1 of 9 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 12:54 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017