Forum: Electrical Tech
09-15-2021, 01:35 PM
|
Replies: 6
Views: 897
Hello Clay,
The relay currently looks to be 3...
Hello Clay,
The relay currently looks to be 3 terminals, however looking below at wiring harness, it appears that it may have been 4 terminal at one point? i.e. I have 2 pics showing relay /...
|
Forum: Electrical Tech
09-12-2021, 07:10 PM
|
Replies: 6
Views: 897
Thanks Johntal,
I actually have this schematic...
Thanks Johntal,
I actually have this schematic as well. It has proved darn near impossible to find manuals illustrating connectors to components. I think next step is to pop relay apart to try to...
|
Forum: Electrical Tech
09-12-2021, 04:38 PM
|
Replies: 9
Views: 1,210
|
Forum: Electrical Tech
09-12-2021, 04:34 PM
|
Replies: 9
Views: 1,210
|
Forum: Electrical Tech
09-12-2021, 02:09 AM
|
Replies: 6
Views: 897
|
Forum: Electrical Tech
09-12-2021, 02:08 AM
|
Replies: 9
Views: 1,210
|
Forum: Electrical Tech
09-12-2021, 02:05 AM
|
Replies: 9
Views: 1,210
|
Forum: Electrical Tech
09-10-2021, 05:54 AM
|
Replies: 6
Views: 897
Heater Relay pin out for 67 GTO
Hello,
Does anyone have the pin out for the heater relay on a 67 GTO? The connector on the original harness is missing and prev owner individually plugged in wires, which are not correct. Any help...
|
Forum: Electrical Tech
09-10-2021, 05:44 AM
|
Replies: 9
Views: 1,210
Hello Goatracer1,
Thx for the response. To...
Hello Goatracer1,
Thx for the response. To answer your question, the resistance wire was replaced w a new harness that has constant 12v, which is what the MSD requires. I would add that I have...
|
Forum: Electrical Tech
09-09-2021, 05:54 PM
|
Replies: 9
Views: 1,210
67 GTO Electrical Problem
Dalco_100
Hello, need help w 67 GTO electrical problem plz.
Intermittent no 12v to distributer (MDS). Determined MDS is fine when hotwired. Issue chased down to inside of bulkhead / ignition...
|
Forum: Suspension TECH
03-07-2018, 04:36 PM
|
Replies: 2
Views: 376
67 GTO Steering gear box question
Hello, I have a 67 GTO and have done some front suspension work. I recently replaced the gear box due to being loose. The one I replaced it with looked the same and bolted up fine. Two issues that...
|
Forum: Pontiac - Street
03-07-2018, 04:19 PM
|
Replies: 41
Views: 2,294
Q Jet fuel leak issue
One other area that can be causing this is the welch plugs that are between the float bowl and throttle body. There are two of them and they are soldered in, which flakes and leaks over time. The fix...
|
Forum: 66-67 GTO Tempest & LeMans TECH
02-24-2014, 08:42 AM
|
Replies: 2
Views: 238
|
Forum: 66-67 GTO Tempest & LeMans TECH
02-20-2014, 03:54 PM
|
Replies: 2
Views: 238
67 GTO front suspension question
Hello,
Continuing to restore a 67 GTO. Question regarding the front suspension. What is the best way to purchase front springs / lifts? I look at the front end and the passenger side sits lower than...
|
Forum: Suspension TECH
09-03-2013, 05:41 PM
|
Replies: 4
Views: 498
67 GTO rear suspension question
Hello, I have a 67 GTO w/400 v8 and 400 THM trans. I have the rear axle out for bushing replacements. The question is actually two fold. I have read in PY (and else where) that there is both a...
|
Forum: 66-67 GTO Tempest & LeMans TECH
07-30-2013, 01:41 PM
|
Replies: 18
Views: 1,115
Bob,
Thanks for the help. Since I am new to...
Bob,
Thanks for the help. Since I am new to this site can you help me with who the host is? I believe in supporting them because this is a great site. Plus appears they are trusted.
Also, from what...
|
Forum: 66-67 GTO Tempest & LeMans TECH
07-29-2013, 08:52 PM
|
Replies: 18
Views: 1,115
67 GTO rear suspension question
Hello, I have a 67 GTO that needs work in the rear axle area.
I have some arms with bushings lined up. My question is regarding the rear springs. I have looked at different sources for springs...
|
Forum: Big Pontiac (incl G-body)Parts For SALE
07-29-2013, 08:42 PM
|
Replies: 3
Views: 150
67 Bonne 400 engine / 400 tranny
Hello,
Need some estimates on what a 67 Bonne 400 engine / 400 tranny is worth. Comes with alternator, ps, fan still on w/belts.
Belonged to an older couple who only used it for church, grocery...
|
Forum: 66-67 GTO Tempest & LeMans TECH
07-14-2013, 01:31 AM
|
Replies: 3
Views: 221
67 GTO washer tank question
Hello, Have a 67 GTO. I have replaced the wiper motor with a rebuilt washer pump (original cycling kind). I am looking at finding the correct OE washer tank. I have been to several shows, catalogs...
|
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED
07-14-2013, 01:21 AM
|
Replies: 0
Views: 289
Set of black seat belts for 67 GTO
Hello, I have a 67 GTO with black interior. I need the seat belts for both front and rear. It currently only has the front driver/ passenger belts. The drivers side works and looks ok. The passengers...
|
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED
07-09-2013, 08:40 AM
|
Replies: 5
Views: 324
67 GTO Heater / A/C duct work
Hello, looking for Heater / A/C duct work in the dash for my 67 GTO. Whomever had the dash out pre my purchase did not reinstall them. This includes the defrost to the vents and heater box. Not had...
|
Forum: 66-67 GTO Tempest & LeMans TECH
07-09-2013, 08:29 AM
|
Replies: 9
Views: 222
Trick to removing seals
Good discussion here but back to your original question: one trick to get those seals out is to simply start the car, turn the steering wheel lock to lock and that blows the seals out. Happens pretty...
|
Forum: Electrical Tech
07-09-2013, 07:53 AM
|
Replies: 8
Views: 262
Ignition issue
I agree with Latech. The only thing to add is that there are two wires from the module to the pick up coil. The wire (usually the white one) becomes brittle after years of moving back and forth...
|
Forum: Heating & Cooling TECH
07-06-2013, 08:43 PM
|
Replies: 3
Views: 189
Many thanks to Old Goat 67
Many thanks Sir!
This is better than I expected and appreciate it very much. And yes, it is an AC car. Forgot to mention that in my original post.
Take care.
|
Forum: Heating & Cooling TECH
07-06-2013, 08:38 AM
|
Replies: 3
Views: 189
Heater vacuum line issues for 67 GTO
Hello,
Have a 67 GTO and has all the vacuum lines in the dash for heater door actuators all unplugged and laying loose (behind glove box). I have the basic repair manual, however not much is shown...
|