Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.09 seconds. Search: Posts Made By: Goatracer1
Forum: 66-67 GTO Tempest & LeMans TECH Yesterday, 09:44 PM
Replies: 4
Views: 131
Posted By Goatracer1
Use a voltmeter or test light and check out the...

Use a voltmeter or test light and check out the system.
Forum: Pontiac - Street 09-10-2024, 07:54 PM
Replies: 35
Views: 1,337
Posted By Goatracer1
It's probably better than what you can buy now.

It's probably better than what you can buy now.
Forum: 66-67 GTO Tempest & LeMans TECH 09-09-2024, 11:32 PM
Replies: 4
Views: 177
Posted By Goatracer1
The shims are slotted so you can start the inside...

The shims are slotted so you can start the inside bolt without worrying about holding the Shims in place too. You start the inside bolt and let the starter hang and slide the shim(s) in. Install the...
Forum: 64-65 GTO Tempest & LeMans TECH 09-09-2024, 11:26 PM
Replies: 5
Views: 401
Posted By Goatracer1
When considering oil amount the crankcase holds 5...

When considering oil amount the crankcase holds 5 quarts. Then add the filter. The old filters held very close to a full quart of oil. The ones today do not.
Forum: Pontiac - Street 09-09-2024, 11:15 PM
Replies: 16
Views: 762
Posted By Goatracer1
I had a piece of the balancer key way break off...

I had a piece of the balancer key way break off and it got caught between the crank gear and timing chain. It broke the chain and caused a piston to hit and bend an intake valve. Pull the balancer at...
Forum: 61-66 Big Pontiac TECH 09-05-2024, 11:32 PM
Replies: 8
Views: 348
Posted By Goatracer1
I thought you meant threaded studs. Yes the...

I thought you meant threaded studs. Yes the 1963-4 have pins(studs) but the 1965 has a threaded stud with a nut on the outside. I don't know yet about the 1962.
Forum: 61-66 Big Pontiac TECH 09-05-2024, 08:26 PM
Replies: 8
Views: 348
Posted By Goatracer1
I hope not. To get into the plenum is a major...

I hope not. To get into the plenum is a major project. I know 1965 did but 1963-4 doesn't.
Forum: Pontiac - Street 09-05-2024, 08:22 PM
Replies: 7
Views: 345
Posted By Goatracer1
Years ago we used a "Weber" regrind in our race...

Years ago we used a "Weber" regrind in our race car with good results.
Forum: 61-66 Big Pontiac TECH 09-04-2024, 10:43 PM
Replies: 8
Views: 348
Posted By Goatracer1
It must be the 2 screws you mentioned that are...

It must be the 2 screws you mentioned that are causing the problem. Does the speaker grille have to come off first or does it stay right on the pad?
Forum: 61-66 Big Pontiac TECH 09-04-2024, 12:16 PM
Replies: 8
Views: 348
Posted By Goatracer1
Dash pad

I tried in the interior section with no response so I will try here. Does anyone know how to remove the dash pad on a 1962 Bonneville? Thanks.
Forum: THE LOBBY 09-04-2024, 12:14 PM
Replies: 12
Views: 725
Posted By Goatracer1
I have subscribed to HRM since 1962 and have a...

I have subscribed to HRM since 1962 and have a copy of every issue since the very first. I will not be renewing.
Forum: Electrical Tech 09-03-2024, 08:44 PM
Replies: 3
Views: 237
Posted By Goatracer1
Watched your video and it looks like you have...

Watched your video and it looks like you have replacement sockets attached to the old harness. With the sockets laying on the floor they are not grounded unless you have added separate ground wires....
Forum: Interior TECH 09-03-2024, 08:35 PM
Replies: 0
Views: 85
Posted By Goatracer1
Dash pad

How is the padded dash top removed from a 1962 Bonneville? Thanks.
Forum: 60 & Older Pontiac TECH 09-01-2024, 10:54 AM
Replies: 4
Views: 214
Posted By Goatracer1
Your oil pressure is higher than your cooling...

Your oil pressure is higher than your cooling system pressure so depending where the leak is the oil could be forced into the cooling system.
Forum: Electrical Tech 09-01-2024, 10:50 AM
Replies: 6
Views: 302
Posted By Goatracer1
If you are not looking for originality run all...

If you are not looking for originality run all your high amp circuit’s through relays. I have done this on all my old cars. It makes a huge difference in the headlights. It also saves the old switches
Forum: 66-67 GTO Tempest & LeMans TECH 08-29-2024, 10:25 PM
Replies: 11
Views: 430
Posted By Goatracer1
I believe it is a 3/8-16 stud.

I believe it is a 3/8-16 stud.
Forum: 66-67 GTO Tempest & LeMans TECH 08-29-2024, 10:23 PM
Replies: 16
Views: 542
Posted By Goatracer1
My first GTO was a factory 4 speed that came...

My first GTO was a factory 4 speed that came without a console. Another route to go.
Forum: 60 & Older Pontiac TECH 08-29-2024, 10:21 PM
Replies: 14
Views: 600
Posted By Goatracer1
When that engine was new people still used...

When that engine was new people still used Alcohol antifreeze thus the need for a low temp thermostat.
Forum: 60 & Older Pontiac TECH 08-29-2024, 10:16 PM
Replies: 6
Views: 188
Posted By Goatracer1
While the 287 has a lot of one year only parts...

While the 287 has a lot of one year only parts they are available. The engine is very reliable but no it isn't fast. The trans may seem odd to new owners but it is a very good design. Before the...
Forum: 66-67 GTO Tempest & LeMans TECH 08-28-2024, 09:46 PM
Replies: 16
Views: 542
Posted By Goatracer1
Don't forget a pilot bearing for the crankshaft.

Don't forget a pilot bearing for the crankshaft.
Forum: 66-67 GTO Tempest & LeMans TECH 08-28-2024, 09:44 PM
Replies: 11
Views: 430
Posted By Goatracer1
Leave the wires connected to the starter. Put a...

Leave the wires connected to the starter. Put a jack under the starter and lower it down enough to remove the wire. Trying to hold it with one hand and working on it with the other hand is a waste of...
Forum: Tri-Power Tech 08-24-2024, 03:10 PM
Replies: 3
Views: 380
Posted By Goatracer1
I don't see any reason why you would have to mask...

I don't see any reason why you would have to mask them off. Just don't spray directly in them.
Forum: Suspension TECH 08-24-2024, 03:07 PM
Replies: 7
Views: 525
Posted By Goatracer1
Ames Rally II lug nut are STAINLESS STEEL.

Ames Rally II lug nut are STAINLESS STEEL.
Forum: THE LOBBY 08-24-2024, 03:00 PM
Replies: 24
Views: 905
Posted By Goatracer1
Dog has been stung twice this summer. Found BIG...

Dog has been stung twice this summer. Found BIG paper nest right next to my lawn mower. Lucky I wasn't stung. Took me a week to kill them all.
Forum: THE LOBBY 08-21-2024, 11:55 PM
Replies: 16
Views: 579
Posted By Goatracer1
Gee aren't you lucky. Here its been in the 60's...

Gee aren't you lucky. Here its been in the 60's with rain.
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 09:17 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017