Does anyone know if there is a document available with dimensions for the location of badges. I understand the molding manual has locations but not dimensions as my restoration manual has. My problem is, after having new quarters installed on my 65' GTO, I do not have holes for the quarter badges and the old quarters were destroyed before I could get the measurements. Thanks, Donnie
|
Cannot believe that nobody has replied. I can tell you this. They do NOT go in the same location as '64s, and I only mention this as a heads up. I've seen this mistake made more than once. I no longer have my '65, so I cannot provide measurements, but surely someone here can. Help a brother out! Good luck. Ron
|
Go to a car show and look for the same car that you know is original and ask if you can measure the location of the badges just to be on safe side.
|
The "GTO Restoration Guide" has diagrams that show the locations but there are no measurements. As jegstek said '65 and '64 differ somewhat.
I notice you are from West Virginia so you can't be too far from Greenville, SC. Drive down to the POCI Nationals in mid July and I guarantee you can get the right measurements. |
Has this been answered elsewhere yet? I'm curious as to the correct locations for a 64, particularly the rear quarters
|
Quote:
|
I am in the same boat with my 66 Lemans. I can measure where t place the badges but I need the template of where to drill the mounting holes.
|
Our questions are answered in this interesting thread. Hit the other links and read up.
http://forums.maxperformanceinc.com/...on#post4696441 |
All times are GMT -4. The time now is 11:19 PM. |