victor Edelbrock heads
I thought these heads were discontinued like 5 years ago . Now BES is selling them . maybe an old ad i guess
//www.besracing.com/cylinder-head-and-intake-packages/cylinder-heads/pontiac/bes-edelbrock-victor |
|
|
Its possible that BES or Butler purchased them while they were still available from Edelbrock and have not sold out of stock yet. But I understand that Edelbrock stopped making these a while ago.
|
Geez 411 cfm at 600 lift.
|
Off set rockers on the intake ?
. |
BES and Butler are the ones that the heads are being produced for, as a signature head.
|
Wish they have a starting point price
|
Quote:
|
Quote:
https://www.jegs.com/i/Edelbrock/350/77849/10002/-1 Clay |
The number I have from sometime ago for Pro Ports by John Marcell. Only have Intake numbers. Note it has a smaller 2.30" valve.
.300 243 .400 318 .500 380 .600 434 .650 447 .700 460 .800 466 .900 460 Stan |
Quote:
|
Quote:
"Estimated to ship direct from manufacturer on 10/27/21 , pending manufacturer availability." Clay |
Quote:
BUT...The new ones very well may be able to be bought from them...I havent heard for sure. |
Sorry,Maybe little off topic. I’m sure if I do enough research I could see the difference in the E heads. I seem to think there may be three or four generations in at this point ? Can anybody educate me on the differences between the three Please. I know one was to help oil return the pan I don’t know the rest of the differences is there a fault in any of the designs that I should not use any longer? I do have an early set of Butler 370 wide ports. not sure if I should retire them? Motor is apart for fresh in up. But look good.
|
How available are the pro port E heads and is anybody running them, flow numbers look good. I see BES and Butler show them.
|
I believe that Tony B and David Butler have the only ability to sell the heads at the current time.
I understand they have some castings and IF you have the $$$$$, Tony will finish them to either 440 cfm or 460 cfm. I talked to David B about this head a week ago. Tom V. |
BES does have a batch of 11 degree heads for the add posted above. You can call BES and talk to Preston to get the exact price but I think they will be around $9000 complete without rockers. I was quoted $6800 if I supplied the cores.
|
Quote:
|
What does your heads flows?
:confused: |
All times are GMT -4. The time now is 02:48 AM. |