Driver Sunvisor won't stay up.
This is one of the last things I need to get done and I can't get the drivers sun visor to stay up. I have tried tightening the screw where it goes into the holder, wrapping some tape on the other side above the mirror, nothing works. It is a new visor and new hardware. Anyone have any suggestions?
|
Not much to suggest if both are new, unless they are a mismatch of visor and shaft size. Some visors used the inner sleeve bush. If not, you may be able to add one, but it's a fair amount thicker than tape. The screws tighten a clamp that locks up of shaft, it's any guess as to if the reproductions are the same of have the screw act more like a grub screw. Are the parts a matching set, same brand, came together etc?
|
Yes, all the same. It all came from Ames
|
I used a Phillips head bit in my 1/4" drive ratchet and torqued the crap out of the screw. Oddly, the driver's side on mine was fine, had to coerce the passenger side. All brand new stuff from Ames.
|
Thanks! I'll give that a try.
|
Once it goes as tight as it can, it's basically done. Get another.
|
All times are GMT -4. The time now is 06:18 AM. |