Band clamps on pypes system
1 Attachment(s)
Hi,
I am installing Pypes SGF70 2.5 exhaust on my 68 bird. Weird question, I am using the Summit 2.5 inch band clamps and they don't seem to fit all that well, if you look at the attached picture I have to use an impact gun to get them even close to sealing. I used band clamps on my Pypes lemans system and they seem to seal all the way, I don't remember it being so much of a force fit. Anyone use Summit 2.5 inch band clamps on their SGF70 install? https://www.summitracing.com/parts/SUM-681250 Thanks! |
Although I don't have Pypes tubing, I used the Summit 2.5" band clamps in one location (per side) on my '66 where the tailpipe slips into the over-axle part. Worked great for me. I used my impact gun to snug them down. No big deal.
https://i.imgur.com/ZK72tM3h.jpg |
Just started reading reviews on these clamps, evidently I am not the only one having this issue, lots of complaints about them being too small. Wish I had read them but I used the same clamps 10 years ago and they worked just fine.
|
Call Summit and ask for a refund or exchange. This isn't the 1st offshore product with which they have had issues.
|
I used them as well, my exhaust guy put them on they worked out well for me.
|
Quote:
They work well. |
I use those band clamps all the time building exhaust systems, however I never tried the summit brand. I always run up to Napa and buy them. Always work as advertised.
|
All times are GMT -4. The time now is 11:29 PM. |