Why can I not find this????
1 Attachment(s)
Looking for the plate to cover this EGR opening but can’t find this shape. Can anyone source one?
|
Because it's not an EGR passage, it's where the hot air choke stove for the automatic choke operation bolts on.
https://i.ibb.co/c6PJhR7/Choke-Stove-Plate.jpg The EGR is vertical, and behind the choke stove in this picture. This is a 1973 Firebird factory cast iron manifold. Edelbrock did have a cast aluminum plate to block that passage back in the late 70s/early 80s, I'm not certain if it's still available, or you ca take a piece of 1/4 inch steel, and fabricate one from scratch. |
Yup. Buy a gasket, put it on a piece of flat steel, shape the steel like the outline of the gasket. Drill two holes. Paint to suit...but the paint may burn off.
|
3/8” aluminum plate would be easier to drill, cut and shape than steel.
Easy project you can do with a drill, hacksaw and a file, using either steel or aluminum plate. |
|
Quote:
|
All times are GMT -4. The time now is 10:51 AM. |