Aftermarket Top Rad Hold down
 

I'm going from mechanical fan to electric fans with a shroud. Looking for a supplier that sells a top plate that holds down the rad. I've seen them before somewhere.

Something like this should work. https://www.summitracing.com/parts/s...2b?seid=srese1

Are you going with fans like this with the shroud? I find they work really good as they have the rubber flaps that also allow air to flow through the radiator at high speeds.
https://www.summitracing.com/parts/t...06?seid=srese1

Are you doing the electric water pump at the same time?

I have a Derale setup with the flaps 16927.
https://www.summitracing.com/parts/der-16927

I was going to ..but looked at the cost of a pump and a new belt setup..too pricey for now. Maybe if I start racing more.

Something similar to that Summit part but would like four holes in the factory location.

Find a busted shroud and trim to taste.

That will get going until I buy or make something.