Showing results 1 to 22 of 22
Search took 0.01 seconds.
Search: Posts Made By: BB70
Forum: THE LOBBY 03-21-2024, 05:03 PM
Replies: 47
Views: 1,087
Posted By BB70
I have a Neon SRT4 that gets a good workout. The...

I have a Neon SRT4 that gets a good workout. The more rust that falls off the quicker it goes.:D
Forum: Interior TECH 01-26-2024, 01:16 AM
Replies: 3
Views: 473
Posted By BB70
I have a 70 GTO with a blue interior in my car...

I have a 70 GTO with a blue interior in my car and had the same question. I need carpet and a headliner so I talked to a salesman at Ames and he sent 3 carpet samples so I could pick the correct...
Forum: Pontiac - Street 12-18-2023, 06:43 PM
Replies: 84
Views: 9,226
Posted By BB70
Man, I think I might have steered you wrong, I...

Man, I think I might have steered you wrong, I thought you had a 69, but you have a 68. I don't know if they come apart the same or not.
Forum: Pontiac - Street 12-18-2023, 11:56 AM
Replies: 84
Views: 9,226
Posted By BB70
If you look at the connector end that goes to the...

If you look at the connector end that goes to the switch, where the opening of the terminals are, there are little squares in the center of each terminal opening. Get a little ground down pick or...
Forum: Pontiac - Street 12-12-2023, 06:25 AM
Replies: 84
Views: 9,226
Posted By BB70
Sometimes when putting in a transmisson, you may...

Sometimes when putting in a transmisson, you may have to readjust the shifter cable or if it has it the linkage that runs up to the steering column from the trans. Do the reverse lights work when put...
Forum: Pontiac - Street 12-11-2023, 07:29 PM
Replies: 84
Views: 9,226
Posted By BB70
Instead of a test light, get a fog light bulb and...

Instead of a test light, get a fog light bulb and use jumper wires, one to the purple wire, one to a good ground. A fog light bulb will work the circuit, nice blinding light is what you want. You can...
Forum: Pontiac - Street 08-21-2023, 08:09 PM
Replies: 8
Views: 555
Posted By BB70
I believe that position is #1 tdc when the plug...

I believe that position is #1 tdc when the plug fires. The 2 gaskets are for if you have a plastic insulator between the pump and timing cover.
Forum: THE LOBBY 08-15-2023, 08:07 PM
Replies: 404
Views: 25,258
Posted By BB70
Had this wrapped in plastic while painting the...

Had this wrapped in plastic while painting the loose parts. Cleaned up the garage some and took the plastic off so I can get block sanding on this now.
Forum: Heating & Cooling TECH 07-20-2023, 11:10 PM
Replies: 5
Views: 746
Posted By BB70
I'm assuming you're just replacing the parts for...

I'm assuming you're just replacing the parts for maitenence reasons. I've always drain the old compressor into a cup, rotate the clutch hub to try to get all the old oil out. Drain the new compressor...
Forum: 70-72 GTO Tempest & LeMans TECH 07-10-2023, 09:13 PM
Replies: 11
Views: 790
Posted By BB70
Zip ties with christmas tree molded on. Probably...

Zip ties with christmas tree molded on. Probably find similar at the parts store.
Forum: 70-72 GTO Tempest & LeMans TECH 04-09-2023, 06:02 PM
Replies: 112
Views: 19,746
Posted By BB70
Looks very nice. You're moving along at a good...

Looks very nice. You're moving along at a good pace it seems like.
Forum: Pontiac - Street 10-05-2022, 07:38 PM
Replies: 40
Views: 4,027
Posted By BB70
Check into finding a radiator repair place and...

Check into finding a radiator repair place and have that one fixed.
Forum: Members Helping Members 04-25-2022, 05:17 AM
Replies: 15
Views: 1,198
Posted By BB70
No Greg, I don't have any part numbers or...

No Greg, I don't have any part numbers or anything. I was just going by the appearance of the hose. The hose that I have used in the past has printing on it saying hi press fuel or something and has...
Forum: Members Helping Members 04-24-2022, 05:03 PM
Replies: 15
Views: 1,198
Posted By BB70
I would follow Sirrotica's advise Greg. There is...

I would follow Sirrotica's advise Greg. There is better quality hose for that, the worm clamps are temporary in my mind. The other type hose clamp you have on there is correct but needs to be...
Forum: Pontiac - Race 04-24-2022, 04:38 PM
Replies: 1
Views: 480
Posted By BB70
I would pull the driveshaft and flex the u joints...

I would pull the driveshaft and flex the u joints to see if one is hurt.
Forum: Pontiac - Race 04-21-2022, 10:56 AM
Replies: 13
Views: 1,010
Posted By BB70
Glad you guys liked it, the announcers were...

Glad you guys liked it, the announcers were pretty lame. It would have been cool to have Sam Posey or maybe Tommy Kendall doing it.
Forum: Pontiac - Race 04-20-2022, 07:18 PM
Replies: 13
Views: 1,010
Posted By BB70
Nostalgia Trans Am race

https://youtu.be/IYaUsZV4DEE

The race has 2 Pontiacs in it, Boss Mustangs, Camaro's- and a nice ending.😁
Forum: Pontiac - Race 04-27-2021, 04:56 PM
Replies: 11
Views: 2,593
Posted By BB70
I used a small cup plug- freeze out plug.

I used a small cup plug- freeze out plug.
Forum: Pontiac - Race 02-28-2020, 10:05 PM
Replies: 25
Views: 3,469
Posted By BB70
I use the good black permatex engine rtv between...

I use the good black permatex engine rtv between the block and tray or scraper. Beforehand wipe both surfaces with brake clean on a paper towel. Use a small bead , go to the inside of the bolt holes...
Forum: Pontiac - Race 02-20-2020, 08:00 PM
Replies: 25
Views: 3,469
Posted By BB70
I have a hydraulic tank fluid level indicator on...

I have a hydraulic tank fluid level indicator on my pan and at idle 1200 rpm's the level has dropped 2 qts. Sorry about the sideways picture.
Forum: Pontiac - Street 11-06-2019, 08:08 PM
Replies: 1
Views: 398
Posted By BB70
What the ex used to say, quit playing with it and...

What the ex used to say, quit playing with it and put it in- lol.
Forum: 66-67 GTO Tempest & LeMans TECH 07-06-2014, 09:42 PM
Replies: 16
Views: 568
Posted By BB70
I believe you should have a gap of .030 or so at...

I believe you should have a gap of .030 or so at the bottom of every tooth that is fully engaged. You can take the solenoid off, bolt up the starter and manually engage the starter drive to...
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -4. The time now is 05:44 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017