Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 2.46 seconds. Search: Posts Made By:
Forum: THE LOBBY Yesterday, 09:16 PM
Replies: 514
Views: 38,420
Posted By 67drake
Took both Pontiacs on about a 40 mile run to get...

Took both Pontiacs on about a 40 mile run to get some burgers and deep fried cheese curds. More of a test for the GTO than anything. Runs just as good as when I parked it in February.
Forum: 61-66 Big Pontiac TECH Yesterday, 08:59 PM
Replies: 6
Views: 85
Posted By stevep
No manual transmission clutch and brake pedal...

No manual transmission clutch and brake pedal trim until 1964 on a B body.
I think that pedal trim was part of the decor group.
Forum: 61-66 Big Pontiac TECH Yesterday, 08:14 PM
Replies: 5
Views: 103
Posted By Bagel
Got it all wired up. So far so good. Hopefully it...

Got it all wired up. So far so good. Hopefully it doesn't randomly go off on me again. Time will tell.
Forum: 70-72 GTO Tempest & LeMans TECH Yesterday, 06:06 PM
Replies: 28
Views: 1,500
Posted By Held for Ransom
Yes. Pontiac called it that. Fremont called it...

Yes. Pontiac called it that. Fremont called it whatever they wanted.
Forum: 70-72 GTO Tempest & LeMans TECH Yesterday, 04:41 PM
Replies: 28
Views: 1,500
Posted By Held for Ransom
C89 Roof Right Left Courtesy Lamp. That's what...

C89 Roof Right Left Courtesy Lamp. That's what I'm going with.

I need to see if I have this already.
Forum: Performance Parts For Sale/Wanted Yesterday, 04:19 PM
Replies: 5
Views: 191
Posted By misterp266
‘67-‘69 f body headers

Doug’s D568. 1 7/8” x 3 1/2”

I am currently fitting these into my ‘63 Catalina Safari. Passenger side is no problem. Drivers side has steering box interference issues but not extreme. Since...
Forum: Pontiac - Street Yesterday, 03:00 PM
Replies: 5
Views: 91
Posted By GOAT8U2
My Moser 12 Bolt Swap, Auto, Driveshaft and Part # Info Inside

Here are some things I'll pass on...

1969 GTO, had 8.2 rear end

Moser 12 Bolt, 3:70 gear, 11" Wilwood brakes, no back brace, powercoated, 33 spline Truetrac, stock axle length = $6000

IF...
Forum: THE LOBBY Yesterday, 02:27 PM
Replies: 17
Views: 690
Posted By besserspat
Yep learned the hard way when I was 18 on a...

Yep learned the hard way when I was 18 on a good.ole Bridgeport mill. The end of my right index finger got chewed off, my foreman almost passed out when I removed the rest of the glove.

The sewn...
Forum: THE LOBBY Yesterday, 02:11 PM
Replies: 18
Views: 400
Posted By Cammer-6
Ive seen dozers with sprocket teeth rebuilt...

Ive seen dozers with sprocket teeth rebuilt using lots of welding rods
no need to get real accurate
Forum: THE LOBBY Yesterday, 02:08 PM
Replies: 6,119
Views: 540,220
Posted By north
You ever wonder how the US won WW2 and put men on...

You ever wonder how the US won WW2 and put men on the moon? It was because of all the guys like your grandfather that the country used to produce prodigiously.
Forum: THE LOBBY Yesterday, 01:45 PM
Replies: 18
Views: 400
Posted By Shiny
You are ambitious! I want to see satellite...

You are ambitious!

I want to see satellite images of Pontiac crop circles when you get this new beast working.
Forum: Pontiac - Street Yesterday, 01:08 PM
Replies: 44
Views: 2,551
Posted By 68bobcat
I cc'd my #62 heads recently. Unmolested...

I cc'd my #62 heads recently. Unmolested November 1968 with new guides and seats. Large valves with screw in studs.
Volume range was 71.7cc to 72.9cc
Forum: Pontiac - Street Yesterday, 12:52 PM
Replies: 33
Views: 973
Posted By JSchmitz
I use Marvel Mystery Oil on occasion. I have seen...

I use Marvel Mystery Oil on occasion. I have seen good results adding it to gas and/or oil. But it is mechanic in a bottle. Helps avoid tearing something down and fixing it correctly. Outside of...
Forum: THE LOBBY Yesterday, 12:31 PM
Replies: 17
Views: 690
Posted By RAJ7395
Just remember to NEVER use glove when you are...

Just remember to NEVER use glove when you are operating a rotating mill, lathe, or drill press!!
Forum: Pontiac - Street Yesterday, 12:19 PM
Replies: 33
Views: 973
Posted By Ram Air IV Jack
I remember these comments you posted months back...

I remember these comments you posted months back regarding Lucas products! Never believed it and also wondered what type of snake oil Lucas is?? Rattlesnake, Garter Snake, etc.!! Further, I also...
Forum: THE LOBBY Yesterday, 12:12 PM
Replies: 17
Views: 690
Posted By 433lemans
Definitely non-permeable gloves. Many people...

Definitely non-permeable gloves. Many people don't realize that you can get severe chemical burns from wet concrete. Some people can do concrete work their whole lives without it happening to them...
Forum: THE LOBBY Yesterday, 12:04 PM
Replies: 514
Views: 38,420
Posted By kingbuzzo
Oh that sounds like a fun run...too bad about yer...

Oh that sounds like a fun run...too bad about yer merc
Forum: Pontiac - Street Yesterday, 12:03 PM
Replies: 11
Views: 1,588
Posted By scott06
not sure if you are still considering this. I run...

not sure if you are still considering this. I run a Spotts 068 HL cam on my stock 65 389. Very nice cam. As others have said pretty sure it is the same as the summit 2801 cam. This should work 100%...
Forum: THE LOBBY Yesterday, 11:36 AM
Replies: 8
Views: 444
Posted By 71GP76TA
Facebook is quickly becoming nothing but scammers...

Facebook is quickly becoming nothing but scammers and t-shirt hustlers.
Forum: Pontiac - Street Yesterday, 11:10 AM
Replies: 40
Views: 2,126
Posted By 78w72
623 torque?? Is that a typo? What kind of dyno? ...

623 torque?? Is that a typo? What kind of dyno? Seems rather high for a 400 with a mild cam.
Forum: THE LOBBY Yesterday, 11:04 AM
Replies: 514
Views: 38,420
Posted By b-man
Thumbs up It’s a different look, a little more emphasis on...

It’s a different look, a little more emphasis on brightwork is a nice change.

I have a few extra sets of grilles so it’s easy to change the look later on if I want. This particular set sat in the...
Forum: THE LOBBY Yesterday, 11:02 AM
Replies: 32
Views: 3,594
Posted By KS circutguy
It only happens in certain States,why is that? ...

It only happens in certain States,why is that?
Cat converters were a real problem here till they stopped letting the thieves get cash for them at bone yards.
They should do the same with wire,stop...
Forum: Interior TECH Yesterday, 10:08 AM
Replies: 12
Views: 212
Posted By HoovDaddy
In 6-12 months you can buy a machine and teach...

In 6-12 months you can buy a machine and teach yourself how to sew. I went through the wait time during Covid. I bought a 1947 singer Commercial machine and learned it pretty quick. Rear...
Forum: Northeast Yesterday, 09:39 AM
Replies: 1
Views: 59
Posted By pontiacs-r-us
We’re headed up in the morning… my first time...

We’re headed up in the morning… my first time attending… weather not looking great…
Forum: THE LOBBY Yesterday, 08:14 AM
Replies: 18
Views: 400
Posted By MarkS57
Yes he did. Didn't keep the D7, we'll see with...

Yes he did. Didn't keep the D7, we'll see with this one.

Anyway:

https://www.youtube.com/watch?v=1r3y-SRsNPI
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 12:48 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017