Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 4 1 23 Last »
Showing results 1 to 25 of 83
Search took 0.03 seconds. Search: Posts Made By: slowbird
Forum: Performance Parts For Sale/Wanted 09-01-2024, 02:00 PM
Replies: 5
Views: 316
Posted By PAUL K
The camshaft housing bores are the same size for...

The camshaft housing bores are the same size for a 50mm roller bearing and 55mm traditional bearing.
Forum: Pontiac - Street 08-01-2024, 09:01 AM
Replies: 7
Views: 319
Posted By i82much
i run two of them as dumb boxes without issue. ...

i run two of them as dumb boxes without issue. distributor controls the timing. i just set the rev limiter.
Forum: Pontiac - Street 07-16-2024, 11:51 AM
Replies: 42
Views: 2,195
Posted By PunchT37
All day.

All day.
Forum: Pontiac - Street 04-21-2024, 09:38 AM
Replies: 55
Views: 8,596
Posted By PAUL K
FWIW many folks have found more power with...

FWIW many folks have found more power with increased air flow using a Quadrajet. Many times folks have found a power gain going from the "750" CFM unit to a large primary venturi "800" CFM unit. Many...
Forum: Pontiac - Street 02-13-2024, 07:50 AM
Replies: 104
Views: 11,038
Posted By ta man
St Thomas opens May 11, Toronto Motorsports park...

St Thomas opens May 11, Toronto Motorsports park hasn't released their schedule, but it may be earlier.
I'm tempted to swap intakes at the track especially if its at TMP..I can usually get more...
Forum: Pontiac - Street 12-25-2023, 08:53 AM
Replies: 19
Views: 1,908
Posted By b-man
Pontiac engines rotate clockwise, as viewed from...

Pontiac engines rotate clockwise, as viewed from the front of the crankshaft.

They’re never referred to as a counterclockwise rotation engine.

Yes the distributor rotates counterclockwise, so...
Forum: Pontiac - Street 12-01-2023, 10:03 AM
Replies: 9
Views: 738
Posted By Half-Inch Stud
I never drilled the pump for increased feed. ...

I never drilled the pump for increased feed.
Cooler line should be in the 25-45PSI range, but i suppose 60 can happen.
Hot fluid exits Case cooler line from Converter. Cooled fluid enter TH400...
Forum: Pontiac - Race 08-14-2023, 02:27 PM
Replies: 135
Views: 26,576
Posted By Tim Corcoran
I am going to put in a plug for Butler...

I am going to put in a plug for Butler Performance just because I think their rotating assembly package is a pretty good deal. The package includes the crank, rods, pistons, rings, wrist pins, and...
Forum: Pontiac - Street 07-10-2023, 07:24 PM
Replies: 2
Views: 449
Posted By 64speed
Pypes fit perfectly

Pypes fit perfectly
Forum: Pontiac - Race 12-31-2022, 05:17 PM
Replies: 47
Views: 7,000
Posted By Stan Weiss
Close to or above 2 G's acceleration rate. ...

Close to or above 2 G's acceleration rate.

Stan
Forum: Pontiac - Race 11-19-2022, 09:37 AM
Replies: 77
Views: 8,480
Posted By nas t eh
FYI He teased, poked, trolled you. You...

FYI
He teased, poked, trolled you.

You responded with intimidation and a threat.
Forum: Pontiac - Race 11-18-2022, 10:53 PM
Replies: 77
Views: 8,480
Posted By scott70
I'm pretty sure you know exactly what my comment...

I'm pretty sure you know exactly what my comment meant...chuckie did. Had nothing to do at all with moderators decisions. I've never had 1 argument with anyone here in all the years I've been on PY....
Forum: Pontiac - Race 11-16-2022, 12:48 AM
Replies: 77
Views: 8,480
Posted By turbo69bird
Take this for what you want but my opinion, It’s...

Take this for what you want but my opinion, It’s his block he paid for it and he can do as he wishes. He should go to Chevy or ford because he didn’t choose your or someone else’s path?
Sorry...
Forum: Pontiac - Street 11-14-2022, 10:14 PM
Replies: 73
Views: 9,984
Posted By johnta1
I think you know why the lifter didn't work? ...

I think you know why the lifter didn't work?

Sorry to see that.

:(
Forum: Pontiac - Street 11-05-2022, 05:15 PM
Replies: 73
Views: 9,984
Posted By mgarblik
I like the plan of an oil change and filter...

I like the plan of an oil change and filter inside inspection. Before you isolate the engine from everything else, a quick check is to set the idle at about 1000 RPM. Use insulated pliers and pull...
Forum: Pontiac - Street 10-08-2022, 11:48 PM
Replies: 61
Views: 4,628
Posted By Sirrotica
My emergency genset is 5000 watts, or 41.66 amps,...

My emergency genset is 5000 watts, or 41.66 amps, it has a 13 HP engine on it. Would it get by with a 5 HP engine, absolutely not.

When the electric fans kick on at a modern car idling, the engine...
Forum: Pontiac - Street 10-08-2022, 08:52 PM
Replies: 61
Views: 4,628
Posted By Bill Hanlon
1 hp = 746 watts. Assuming 100% efficiency...

1 hp = 746 watts.

Assuming 100% efficiency in the alternator (all physical energy used to spin the alternator is converted to electrical energy output, no losses to heat, friction or the...
Forum: Pontiac - Race 08-14-2022, 12:46 PM
Replies: 9
Views: 1,124
Posted By gman005
9.34 @142

9.34 @142
Forum: Pontiac - Race 07-08-2022, 02:49 PM
Replies: 90
Views: 11,024
Posted By PAUL K
If you are going that far with the list John...

If you are going that far with the list John Langer and Bruce Miachles should mentioned..... The two King's
Forum: Pontiac - Street 06-19-2022, 03:06 PM
Replies: 95
Views: 18,902
Posted By i82much
i thought we were only allowed to run 068, 041,...

i thought we were only allowed to run 068, 041, or old faithful in the street section anyway ...
Forum: Pontiac - Race 06-12-2022, 01:15 PM
Replies: 76
Views: 10,746
Posted By grandville455
Never do burnouts in 1st and then hitting second!...

Never do burnouts in 1st and then hitting second! Either start in 2nd and then get into high gear asap or just start in high like brian said , the 1-2 raises hell on the sprag!
Forum: Pontiac - Street 05-01-2022, 10:12 AM
Replies: 95
Views: 8,612
Posted By Stan Weiss
Joe South - Games People Play :pound: Stan

Joe South - Games People Play :pound:

Stan
Forum: Pontiac - Street 04-17-2022, 06:47 PM
Replies: 225
Views: 24,231
Posted By Cliff R
Determining converter stall is easy with a TH350...

Determining converter stall is easy with a TH350 or TH400.

Disconnect the kick-down cable on your TH350 (if used) or the downshift solenoid on the TH400.

With the engine, trans etc fully...
Forum: Pontiac - Race 03-05-2022, 03:24 PM
Replies: 16
Views: 1,840
Posted By Probird
12-14” is just about right. I’m not sure why it...

12-14” is just about right. I’m not sure why it would be hurting anything only being that high. Just get good adjustable shocks on the front. Use those to soften the landing. My car runs best when...
Forum: Pontiac - Race 03-04-2022, 08:59 PM
Replies: 45
Views: 7,414
Posted By mysticmissle
Geez

Geez
Showing results 1 to 25 of 83
Page 1 of 4 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 04:30 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017