Showing results 1 to 25 of 255
Search took 0.04 seconds.
Search: Posts Made By: JSchmitz
Forum: Performance Parts For Sale/Wanted 09-18-2024, 01:46 PM
Replies: 3
Views: 172
Posted By JSchmitz
I'm finally back in style!!! :) ...

I'm finally back in style!!! :)

https://forums.maxperformanceinc.com/forums/attachment.php?attachmentid=640169&stc=1&d=1726681585
Forum: Collectibles WANTED 09-13-2024, 12:45 PM
Replies: 8
Views: 821
Posted By JSchmitz
Like these? :) ...

Like these? :)

https://forums.maxperformanceinc.com/forums/attachment.php?attachmentid=639906&stc=1&d=1726245894
Forum: THE LOBBY 09-13-2024, 12:39 PM
Replies: 4
Views: 369
Posted By JSchmitz
My old Rotary came with these. They are...

My old Rotary came with these. They are excellent!

https://forums.maxperformanceinc.com/forums/attachment.php?attachmentid=639905&stc=1&d=1726245537
Forum: THE LOBBY 09-02-2024, 09:44 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
My lift came with Rotary door protectors on it...

My lift came with Rotary door protectors on it (big foam pads). They are a life saver!
Forum: THE LOBBY 09-02-2024, 09:43 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
https://forums.maxperformanceinc.com/forums/attach...

https://forums.maxperformanceinc.com/forums/attachment.php?attachmentid=639306&stc=1&d=1725284574
Forum: THE LOBBY 09-02-2024, 09:31 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
The seals were crumbling apart... This supposedly...

The seals were crumbling apart... This supposedly came from a Ford dealership. Must have a million lifts on it. I found it on Craigslist for $850! Still can't believe it. It's not very pretty. But...
Forum: THE LOBBY 09-02-2024, 09:23 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
When they say it requires a 12' ceiling, they...

When they say it requires a 12' ceiling, they mean it! I don't think I have an inch between the top of mine when raised to the limit.
Forum: THE LOBBY 09-02-2024, 09:21 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
I bought my home used. I wasn't sure about the...

I bought my home used. I wasn't sure about the floor thickness. So I drilled and measured. My floor is 5-1/2" with fiberglass reinforcement. So I went with it. So far so good. Mine is an older...
Forum: THE LOBBY 09-01-2024, 10:38 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
https://forums.maxperformanceinc.com/forums/attach...

https://forums.maxperformanceinc.com/forums/attachment.php?attachmentid=639239&stc=1&d=1725201414

Here's a page from my installation manual. Looks like 14' to rear, from centerline, and 10' in...
Forum: THE LOBBY 09-01-2024, 07:46 AM
Replies: 29
Views: 1,185
Posted By JSchmitz
It also depends on if it's a standard or...

It also depends on if it's a standard or asymmetric lift. Mine is an asymmetric Rotary. The post are farther forward relative to the vehicle. I'll look in my install manual and see if it calls this...
Forum: THE LOBBY 08-07-2024, 05:22 PM
Replies: 12
Views: 553
Posted By JSchmitz
My MRI's have all been cake. I listen to KSHE 95...

My MRI's have all been cake. I listen to KSHE 95 and take a nap. The banging is pretty loud. One time I forgot to take my belt off. The little buckle about lifted me off the table! That's serious...
Forum: THE LOBBY 08-02-2024, 07:45 AM
Replies: 82
Views: 5,469
Posted By JSchmitz
Sorry, I forgot to follow up. I didn't get quite...

Sorry, I forgot to follow up. I didn't get quite what I wanted. But I'm ok with it. My experience with BaT was good. They were very thorough and responsive. The secure checkout company, Caramel, was...
Forum: THE LOBBY 07-10-2024, 06:09 PM
Replies: 13
Views: 990
Posted By JSchmitz
Happy birthday to a racing legend! Simply amazing!

Happy birthday to a racing legend! Simply amazing!
Forum: Electrical Tech 07-09-2024, 08:27 AM
Replies: 16
Views: 880
Posted By JSchmitz
I only had to cut a small part out. Looks fine to...

I only had to cut a small part out. Looks fine to me.
Forum: Pontiac - Street 07-04-2024, 08:51 PM
Replies: 7
Views: 661
Posted By JSchmitz
Make sure base condition is good first. Check...

Make sure base condition is good first. Check float levels and power valves aren’t blown, etc
Forum: Pontiac - Street 07-03-2024, 06:09 PM
Replies: 56
Views: 10,234
Posted By JSchmitz
When I was young I had to drive my GTO in the...

When I was young I had to drive my GTO in the snow a few times. Had to drive it to work because I had no choice. Put a few hundred pounds of sand in the trunk. It did just fine. A lot of people...
Forum: THE LOBBY 06-26-2024, 09:03 AM
Replies: 28
Views: 1,960
Posted By JSchmitz
I have AFM on my 2011 Camaro. It worked...

I have AFM on my 2011 Camaro. It worked seamlessly. The only thing I didn't like was an obnoxious tone from the exhaust when it would switch back to 8 cylinders. I have aftermarket exhaust. So it's...
Forum: Suspension TECH 06-25-2024, 07:50 AM
Replies: 25
Views: 1,798
Posted By JSchmitz
Up on some blocks as stated. Also one of these: ...

Up on some blocks as stated. Also one of these:
...
Forum: Pontiac - Street 06-18-2024, 04:26 PM
Replies: 14
Views: 874
Posted By JSchmitz
Yeah, it'll make your plugs black!!! :pound:

Yeah, it'll make your plugs black!!! :pound:
Forum: Pontiac - Street 06-18-2024, 11:45 AM
Replies: 14
Views: 874
Posted By JSchmitz
Good point. I was assuming old school Holley....

Good point. I was assuming old school Holley. :confused:
Forum: Pontiac - Street 06-18-2024, 10:35 AM
Replies: 14
Views: 874
Posted By JSchmitz
I always set it to where the fuel will slosh out...

I always set it to where the fuel will slosh out if I rock the car slightly. Definitely not half way up. The preset factory level just gets you close. Individual fuel pressures, etc., affect where it...
Forum: THE LOBBY 06-13-2024, 03:35 PM
Replies: 13
Views: 1,028
Posted By JSchmitz
NICE! Congrats on the car and the wife! :)

NICE! Congrats on the car and the wife! :)
Forum: THE LOBBY 06-10-2024, 12:33 PM
Replies: 65
Views: 5,902
Posted By JSchmitz
Nice! Everyone was telling me that, "I...

Nice!

Everyone was telling me that, "I better have a plan", etc. I was gonna get bored, depressed. I told them that ain't me! I still feel like I don't get enough done. My lists are as long as...
Forum: Pontiac - Street 06-10-2024, 10:48 AM
Replies: 62
Views: 7,002
Posted By JSchmitz
Glad to hear that you found something to improve...

Glad to hear that you found something to improve your problem.
Forum: THE LOBBY 06-10-2024, 10:45 AM
Replies: 65
Views: 5,902
Posted By JSchmitz
I retired 2/15/24. It was my 31st anniversary...

I retired 2/15/24. It was my 31st anniversary with the company. It's like living in a dream world! :) Best of luck to you! Enjoy!
Showing results 1 to 25 of 255

 
Forum Jump

All times are GMT -4. The time now is 02:43 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017