Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 9 1 23 Last »
Showing results 1 to 25 of 217
Search took 0.06 seconds. Search: Posts Made By: PunchT37
Forum: Pontiac - Street 09-18-2024, 05:38 PM
Replies: 39
Views: 1,585
Posted By PunchT37
Unless you have a 350 Buick. ;)

Unless you have a 350 Buick. ;)
Forum: Pontiac - Street 09-05-2024, 09:09 PM
Replies: 34
Views: 1,231
Posted By PunchT37
I just sold a 455 with stock rods. Stock bolts....

I just sold a 455 with stock rods. Stock bolts. Built in the `80`s. 5600 to 5700 rpm`s. Running low 12`s to high 11`s. No problems. Sold that motor for more than I asked for. Still running good...
Forum: Pontiac - Street 09-05-2024, 05:54 PM
Replies: 34
Views: 1,231
Posted By PunchT37
Yep. Just dropped a set of 8 rubber rods in the...

Yep. Just dropped a set of 8 rubber rods in the trash that I paid $275 for back in the day. Not worth the trouble today for heat treat, etc.
Forum: Pontiac - Street 07-30-2024, 09:57 PM
Replies: 13
Views: 518
Posted By PunchT37
Yep. Factory. They are rare these days in a...

Yep. Factory.

They are rare these days in a 400. They are not detonation prone like the trash replacement ones usually found on stock rebuilds.
Forum: Pontiac - Street 07-30-2024, 08:41 PM
Replies: 13
Views: 518
Posted By PunchT37
I can`t see the pistons.

I can`t see the pistons.
Forum: Pontiac - Street 07-26-2024, 10:17 PM
Replies: 5
Views: 380
Posted By PunchT37
I got mine from Ames. Perfect.

I got mine from Ames. Perfect.
Forum: Pontiac - Street 07-26-2024, 08:44 AM
Replies: 9
Views: 569
Posted By PunchT37
I have one on mine. Road Paver cam with .400...

I have one on mine. Road Paver cam with .400 lobe. No problems. Mine doesn`t have any markings.
Forum: Pontiac - Street 07-26-2024, 06:50 AM
Replies: 20
Views: 5,985
Posted By PunchT37
I ran a flex fan off a `69 Judge [still have it]...

I ran a flex fan off a `69 Judge [still have it] for many years on a 480`ish hp 455. No problems down here in south Louisiana. BUT, I found out the judge had a smaller crank pulley than an a/c car....
Forum: Pontiac - Street 07-22-2024, 03:29 PM
Replies: 86
Views: 5,068
Posted By PunchT37
Build that 400 and speed shift that muncie.

Build that 400 and speed shift that muncie.
Forum: Pontiac - Street 07-21-2024, 01:06 PM
Replies: 40
Views: 2,086
Posted By PunchT37
One can see why here; ...

One can see why here;




https://www.gtoforum.com/attachments/original-pontiac-744-cam-on-left-jpg.136356/
Forum: Pontiac - Street 07-16-2024, 11:51 AM
Replies: 42
Views: 2,180
Posted By PunchT37
All day.

All day.
Forum: THE LOBBY 06-27-2024, 08:12 AM
Replies: 28
Views: 1,957
Posted By PunchT37
They will never be as reliable as the old LM7...

They will never be as reliable as the old LM7 that I still have. But, my brother has a 2007 5.3 with AFM that has 138,000 miles. Runs like a clock. Very quiet, no oil leaks, etc. My co worker has a...
Forum: THE LOBBY 06-26-2024, 10:57 PM
Replies: 28
Views: 1,957
Posted By PunchT37
And these lifters have been around for 17 yrs or...

And these lifters have been around for 17 yrs or so.
Forum: Pontiac - Street 06-12-2024, 05:31 PM
Replies: 40
Views: 1,871
Posted By PunchT37
That cast crank will outlast that 8.2 rear.;)

That cast crank will outlast that 8.2 rear.;)
Forum: THE LOBBY 05-20-2024, 06:39 AM
Replies: 63
Views: 3,936
Posted By PunchT37
50 yrs ago I was 10 years old cutting grass and...

50 yrs ago I was 10 years old cutting grass and building tree houses.
Forum: THE LOBBY 05-11-2024, 05:18 PM
Replies: 1
Views: 474
Posted By PunchT37
Ya`ll wanna chew on this?

Again?


https://www.youtube.com/watch?v=8FVBKs7cDGY
Forum: Pontiac - Street 04-23-2024, 08:30 PM
Replies: 68
Views: 7,276
Posted By PunchT37
Should be good to go.

Should be good to go.
Forum: Pontiac - Street 04-06-2024, 09:04 PM
Replies: 13
Views: 1,038
Posted By PunchT37
Check you sender ground 1`st. Black wire that...

Check you sender ground 1`st. Black wire that bolts to the car underside somewhere.

Total ground = empty.
NO ground = full, to past full.
Forum: Pontiac - Street 04-03-2024, 06:29 PM
Replies: 21
Views: 3,037
Posted By PunchT37
That should get you 550 to 600 hp if all is good...

That should get you 550 to 600 hp if all is good in your parts selection.
Forum: Pontiac - Street 03-01-2024, 11:58 AM
Replies: 30
Views: 2,385
Posted By PunchT37
I believe the `75 is the oddball. `76 and `77...

I believe the `75 is the oddball. `76 and `77 carbs are some of the best ones.
Forum: Pontiac - Street 02-28-2024, 03:33 PM
Replies: 26
Views: 2,755
Posted By PunchT37
Check for crap in the bottom of the bolt holes in...

Check for crap in the bottom of the bolt holes in the block for the head bolts.

Also, have the heads been milled a good bit?
Forum: Pontiac - Street 02-17-2024, 11:21 AM
Replies: 81
Views: 13,750
Posted By PunchT37
I wonder if any engine is finished breaking in...

I wonder if any engine is finished breaking in after 20 to 30 minutes?
Forum: Pontiac - Street 02-14-2024, 04:09 PM
Replies: 61
Views: 3,839
Posted By PunchT37
My `71 T37 was 3660 a while back. With me in it....

My `71 T37 was 3660 a while back. With me in it. Iron heads, aluminum intake with headers. A/C compressor gone but, had the rest of the system.


455, t400, 12 bolt. Full interior.
Forum: Pontiac - Street 02-07-2024, 10:04 PM
Replies: 44
Views: 5,138
Posted By PunchT37
What Paul said above is a budget way to go. 068...

What Paul said above is a budget way to go. 068 with 1.65 rockers. That will give you .448 lift. With 212/225 at 050, that will be a decent step up without going to big valves and screw in studs.
Forum: Pontiac - Street 02-07-2024, 09:32 PM
Replies: 44
Views: 5,138
Posted By PunchT37
There were 15 heads in `68 also. More like a 75...

There were 15 heads in `68 also. More like a 75 to 78 cc chamber.
Showing results 1 to 25 of 217
Page 1 of 9 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 07:35 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017