Forum: Pontiac - Street
Today, 08:25 AM
|
|
Replies: 29
Views: 697
|
|
Forum: Pontiac - Street
Today, 05:40 AM
|
|
Replies: 10
Views: 268
Couple of things to mention.
IF you install...
Couple of things to mention.
IF you install a new SI style alternator make sure that the battery is FULLY charged. If you don't it goes to full charge and works the piss out of the regulator and...
|
|
Forum: Pontiac - Street
Today, 04:54 AM
|
|
Replies: 7
Views: 173
They are difficult to remove without damaging...
They are difficult to remove without damaging them.
Replacements are available but they are not OEM quality, so I don't stock them. If and when I've needed to replace them I'll remove the bottom...
|
|
Forum: Pontiac - Street
Today, 03:50 AM
|
|
Replies: 10
Views: 268
|
|
Forum: THE LOBBY
Today, 01:04 AM
|
|
Replies: 101
Views: 4,482
|
|
Forum: THE LOBBY
Yesterday, 11:10 PM
|
|
Replies: 101
Views: 4,482
|
|
Forum: Pontiac - Street
Yesterday, 10:49 PM
|
|
Replies: 3
Views: 161
|
|
Forum: Pontiac - Street
Yesterday, 08:32 PM
|
|
Replies: 29
Views: 697
|
|
Forum: Pontiac - Street
Yesterday, 05:51 PM
|
|
Replies: 11
Views: 358
|
|
Forum: Pontiac - Street
Yesterday, 05:31 PM
|
|
Replies: 8
Views: 202
|
|
Forum: Pontiac - Street
Yesterday, 04:30 PM
|
|
Replies: 15
Views: 317
|
|
Forum: 66-67 GTO Tempest & LeMans TECH
Yesterday, 04:21 PM
|
|
Replies: 4
Views: 116
|
|
Forum: Pontiac - Street
Yesterday, 04:05 PM
|
|
Replies: 15
Views: 317
I have always had the opinion that as far as...
I have always had the opinion that as far as valve train stress you are better off getting lift with the cam and not the rocker arms.
Its cheaper too if you already have the 1.5 rockers and not the...
|
|
Forum: Pontiac - Street
Yesterday, 03:34 PM
|
|
Replies: 8
Views: 202
|
|
Forum: THE LOBBY
Yesterday, 03:29 PM
|
|
Replies: 3
Views: 247
|
|
Forum: Pontiac - Street
Yesterday, 03:11 PM
|
|
Replies: 8
Views: 202
When I was shopping for my setup, I went in...
When I was shopping for my setup, I went in looking at a forged crank. Butler talked me out of it and told me that a cast crank would be just fine if I'm not running any power adders. If you chose to...
|
|
Forum: Pontiac - Street
Yesterday, 02:25 PM
|
|
Replies: 29
Views: 697
|
|
Forum: 67-69 Firebird TECH
Yesterday, 01:59 PM
|
|
Replies: 16
Views: 730
|
|
Forum: Pontiac - Street
Yesterday, 11:59 AM
|
|
Replies: 25
Views: 754
I read of that, and looked into it;
The...
I read of that, and looked into it;
The purported "067" cam is actually another 066 replacement cam; but don't just take my word for it, here are the spec's:
Butler exclusive "067-RA" specs:
...
|
|
Forum: Electrical Tech
Yesterday, 11:49 AM
|
|
Replies: 5
Views: 136
Back-up lamp switch= Muncie 4 speed transmission
Here is a jpeg from a long time ago. This is a 66 GTO 4 speed transmission but a 65 GTO would be the same as far as that reverse lamp switch and wiring goes.
Where the twin wires pass thru the...
|
|
Forum: Pontiac - Street
Yesterday, 11:33 AM
|
|
Replies: 13
Views: 291
|
|
Forum: Pontiac - Street
Yesterday, 11:30 AM
|
|
Replies: 25
Views: 754
Couple things.
Most machine shops now use a...
Couple things.
Most machine shops now use a finish of 50 as SOP, since many OEs use steel gaskets, AND because many request it due to aluminum head availability.
Quench. Quench makes a...
|
|
Forum: Pontiac - Street
Yesterday, 10:06 AM
|
|
Replies: 29
Views: 697
Just to say, gapless rings are junk IMO. I've...
Just to say, gapless rings are junk IMO. I've seen many have issues with them. Blowby being one of them. They can 'stick' together and not compress right and wear fast. I think they are more of a...
|
|
Forum: THE LOBBY
Yesterday, 08:33 AM
|
|
Replies: 3
Views: 247
R89 w/ topper
Saw this at a swap the other day, the guy cut the case top off, used a topper, and real caps, the topper caps are crappy. The eye is red too on the topper which looks bad. This battery he did...
|
|
Forum: Pontiac - Street
Yesterday, 08:23 AM
|
|
Replies: 13
Views: 291
|
