Showing Visitor Messages 1 to 6 of 6
-
Hey John - been a while - I was hoping to get some info about the small water pump you use to inject water into the exhaust side of the head where it is modified to let water cross over between the exhast seats - It looks like I have reached the point of needing one. Thanks Curt
-
-
John, Do you run King bearings. Are they a good bearing and do they make them for a Pontiac 3in main and regular size Pontiac connecting rods. Your help is greatly appreciated. Thank You Rusty
-
did you notice the picture of the intake side of the heads in the last post of the "tiger dyno" thread?
-
John -- do you run aluminum rods - and if so did you have to clearance the block for them - -4.5 in stroke
curt
-
Are you going to the Pontiac Nationals this year?