Conversation Between Jeff Kinsler and potentpontiac
Showing Visitor Messages 1 to 5 of 5
-
Hey there Jeff. What do you run for timing set up on your motor, Belt drive, or chain set up. I have has issues with my 505 with the Rollmaster red series cam sprocket and Simms torrington thrust plate deal. I have 50mm roller cam bearings and for some reason, I have had issues with wear problems with the cam sprocket. I need some advise on this to correct the problem. Thanks, Mike.
-
I cant find the pics I had from a long time ago, but they take like a dremel and make a path in the block where the bearing sits and then drill a hole in the bearing where that path ends. Hard to explain. They do the same dremel path in the crank. I will try and look for pics again. You having oiling issues?
-
Hey Jeff. I was Interested to know what you guys modify in the main are of the aftermarket blocks. I enlarge the oil holes slightly and also to the main bearings. Do you have any Info on mods in this area. Thanks.
-
No I do not, are they different from steel and aluminum blocks? I run a steel block.
-
Hi Jeff. Do you have any pics of the Aluminum block oil hole mods. I have my IA2 apart and wanted to see what you have got going on in the main saddle area. Thanks, Mike.