[Mike Kasparian,Sr.]

8 JE coated pistons for 4.350 bore , 1.200 cd ht . and 7 casidiam coated pins . Pistons ordered for first gen tiger heads . 350.00 plus shipping .

[Darren 639]

If I use a 4.50 stroke crankshaft what size rod will I need? Thank you
Darren.

[Mike Kasparian,Sr.]

It depends on deck ht to give exact length . With a deck ht of 10.200 for example rod length would be 6.750 . You would need custom rods .

[Darren 639]

Hi Mike i am building a IA standard height block.I have the 4.5 crank I need to measure bore but i do think it will finish at 4.350 one more calculation to make is i bought don's RA5 heads so i need to see if valve relief is correct and compression will be with your piston. I will ask don to check on this for me i hope it works.

[Mike Kasparian,Sr.]

Don would know about valve spacing for tiger vs ra5 . Not sure if it will work , I know valve layout is different .

[Mike Kasparian,Sr.]

Bump

[dci]

Hi Mike, When you get a chance give me a call.

Thanks,

[Mike Kasparian,Sr.]

Bump

[Mike Kasparian,Sr.]

TTT

[Mike Kasparian,Sr.]

Bump

[Mike Kasparian,Sr.]

TTT

[Mike Kasparian,Sr.]

Bump

[Dragncar]

What was the original intent. As in stroke and rod length ? Whats the dome ccs. Can they be used with E heads or HPs ? Why only 7 pins.

[Mike Kasparian,Sr.]

4.25 stroke , 6.900 rod ( depending on deck ht.) , flat tops , broke a rod and threw piston and pin away .

[racegto65]

Mike I'm interested but was wondering if you could measure them.
I have a block already at 4.350 and need to know what the wall
clearance will be.

Thanks.

[Mike Kasparian,Sr.]

Ok , I will try and measure tomorrow and post.

[Dragncar]

Have some 6.875 Crower billets. Would work but piston would be .025 in the hole right ?

[Mike Kasparian,Sr.]

Need to know deck ht to tell for sure .

[Mike Kasparian,Sr.]

Sold