| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-09-2024, 07:48 PM
|
||||
|
||||
th400 slow to shift
1-2 2-3 slooow. at wot. 60ft. great. Thought lazy governor but on tear down got around .070 at intermediate clutch. Steels are .100 and 2 frictions at ..078 and 1 at .090. IS THIS MY PROBLEM? No sign of air leak at intermediate clutch. Thanks Shifts not firm at low rpm manually shifting also.
|
|
#2
06-10-2024, 03:22 AM
|
|||
|
|||
|
Could be a lot of things.
What mods have been done to the transmission ? Start there first. |
|
#3
06-10-2024, 07:44 AM
|
||||
|
||||
|
Check center Support shaft-Bushing Play for massive HYD Leak. Tighten packs to 060" all flat steels. Trim up Vac Mod 2-turns CW.
Is the Dir Drum mid-seal and 2nd center support ring out for full-apply? That deal needs the tinyRev bleed plugged in the Separator Plate. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
