Nice project!
The alignment holes in the subframe are actually 5/8" holes. I used 1/2" copper tubing to align mine. It is actually 1/2" ID, 5/8" OD. You can also take a lot of measurements before removing it which should confirm that you have it back right where it was.
I assume you're going to blast that core support while you have it off?
Depending on the build date of the car, that engine color could be factory correct. If it's prior to April 15th, you're good. After would be the slate blue like you see on so many SD cars.
Good luck with your project and ask away. That's why we all visit here.
__________________
Bob Woodard
Brighton, MI
2012 SRT8 Charger - 12.70 @ 111mph
|