Question on the drive shaft ends:
1-Trans yoke ? 32 spline output from M-22/T400 to a 3R series U-joint? (Spicer 5-795X u-joint?). Also long (7 5/8 end to center of joint) or short (5 3/8 end to center of joint)???
2-Pinion flange end again Spicer 5-795X u-joint? I measured my pinion flange on diff and it comes in at 3 5/8 wide with 1 1/8 end cap width. this joint uses inside retainer clips like stock pontiac.
Thanks for help
|