Good point about the pulley alignment. I was only planning on removing the minimum amount to get reasonable gasket surfaces. So hopefully I won't be having to make custom pulley spacers too. 🙂
I have one cover that is badly cracked around one of bottom though bolts. I was going to use it as a test piece.
Thanks for your input.
__________________
If it breaks. I didn't want it in the first place.
_____________________________________________
69 GTO \ 72 FIREBIRD \ 1/2 OF A 64 GTO \ 70 JAVELIN \ 52 FORD PU \ 51 GMC PU \ 29 FORD PU \ 85 ALFA ROMEO SPYDER \ A HANDFUL OF ODD DUCATI'S \ 88 S10 LT1 BLAZER & MY DAILY DRIVER 67 SUBURBAN.
|