opinions on 66 console fit
5 Attachment(s)
It's been a few years since I installed a console in a 66, but I seem to remember them fitting better than this. This car is a factory console car, with the front OEM bracket still bolted to the floor, the car has had the front half of a 1 piece floor installed, rockers are original. The shifter porch is a round hole GM, but not sure if it's a Pontiac piece or not. There's almost an inch gap at the front / side mounting hole in the plastic base, making the original screws too short, and the round shifter hole is a little offset from the cup. Any ideas?
|
I installed the shifter today and it was centered in the cup, no issues there, I did have to move the front console bracket back about a 1/4 inch, everything looks good now.
|
All times are GMT -4. The time now is 01:17 PM. |