Showing results 1 to 25 of 28
Search took 0.02 seconds.
Search: Posts Made By: Dens71TA
Forum: 70-73 Firebird & TA TECH 02-07-2021, 01:06 PM
Replies: 8
Views: 1,698
Posted By Dens71TA
Trico part number for the entire original style...

Trico part number for the entire original style wiper blade assembly is 18-2. Discontinued for 5+ years but there still seems to be a supply of them on eBay.

Part number for the discontinued...
Forum: THE LOBBY 01-26-2021, 09:32 AM
Replies: 5
Views: 716
Posted By Dens71TA
Typically the entire wiper system components are...

Typically the entire wiper system components are different between non-hidden and hidden. The non-hidden arms have a bend in them so they stay above the hood edge. Driver's side wiper blade is also...
Forum: THE LOBBY 02-06-2018, 07:13 PM
Replies: 94
Views: 7,020
Posted By Dens71TA
Fifteen inch Firestone Indy 500 Firehawk tires...

Fifteen inch Firestone Indy 500 Firehawk tires were discontinued towards the end of 2011 so at best they are already around 7 years old.
Forum: 70-73 Firebird & TA TECH 02-19-2014, 09:47 PM
Replies: 26
Views: 2,036
Posted By Dens71TA
Round port heads, gotta be a Ram Air IV.

Round port heads, gotta be a Ram Air IV.
Forum: 70-73 Firebird & TA TECH 02-19-2014, 12:33 AM
Replies: 815
Views: 74,939
Posted By Dens71TA
Concours restored, older restorations, drivers,...

Concours restored, older restorations, drivers, and mine would currently fall under nightmare project.
Forum: 70-73 Firebird & TA TECH 02-18-2014, 11:52 PM
Replies: 815
Views: 74,939
Posted By Dens71TA
'71s are dime a dozen around here. There are...

'71s are dime a dozen around here. There are two within minutes of me along with a few more not much farther. I forget the total amount but there are at least ten '70-72 T/As in the area.
Forum: 70-73 Firebird & TA TECH 02-18-2014, 03:57 AM
Replies: 14
Views: 1,338
Posted By Dens71TA
There was a Kent Moore J-tool for removing the...

There was a Kent Moore J-tool for removing the front half of the booster. It was basically a piece of box tubing and flat steel that attached where the master cylinder goes. Then you use a large...
Forum: THE LOBBY 02-06-2014, 01:28 AM
Replies: 14
Views: 1,271
Posted By Dens71TA
While you were looking inside the case, did you...

While you were looking inside the case, did you check for bulging or leaking capacitors on the system board? Common problem on Dells(especially WinXP vintage machines). Usually a good indicator on...
Forum: 70-73 Firebird & TA TECH 01-22-2014, 09:46 PM
Replies: 12
Views: 1,063
Posted By Dens71TA
Are you looking for the coat hanger or the buckle...

Are you looking for the coat hanger or the buckle clip?

http://forums.maxperformanceinc.com/forums/attachment.php?attachmentid=95926&d=1182982102
Forum: THE LOBBY 01-18-2014, 11:25 PM
Replies: 78
Views: 6,354
Posted By Dens71TA
Quote from a Legend Gear employee on a Buick...

Quote from a Legend Gear employee on a Buick forum:
Forum: 70-73 Firebird & TA TECH 01-18-2014, 03:11 PM
Replies: 7
Views: 471
Posted By Dens71TA
I have never seen a clip installed there before. ...

I have never seen a clip installed there before. It does look factory. On a few rare occasions I have seen some small brackets or parts for Camaro and Chevrolet engine cars accidentally installed...
Forum: 70-73 Firebird & TA TECH 01-13-2014, 02:21 AM
Replies: 5
Views: 401
Posted By Dens71TA
Yes, the torx head bolt(basically a door latch...

Yes, the torx head bolt(basically a door latch striker) was used on all the seats.
Forum: 70-73 Firebird & TA TECH 01-11-2014, 05:07 PM
Replies: 17
Views: 938
Posted By Dens71TA
There are two bolts securing it to the fender...

There are two bolts securing it to the fender that have to be accessed from the engine compartment, one bolt at the bottom attaching it to the center spoiler, and three sheet metal screws attaching...
Forum: 70-73 Firebird & TA TECH 01-07-2014, 08:58 PM
Replies: 48
Views: 2,917
Posted By Dens71TA
That was me in late 1999/early 2000. Started...

That was me in late 1999/early 2000. Started looking at '77-78 cars, for a little more I could get an earlier car, save up some more money and start looking at '74-76 cars, for little more I can...
Forum: 70-73 Firebird & TA TECH 01-05-2014, 11:31 PM
Replies: 48
Views: 2,917
Posted By Dens71TA
Looks like there is an ungodly amount of work...

Looks like there is an ungodly amount of work there to get those cars even in presentable driver condition. Life is too short to work on rusty cars. I learned that one the hard way!
Forum: THE LOBBY 12-29-2013, 12:38 AM
Replies: 108
Views: 4,767
Posted By Dens71TA
As the owner of a Trans Am with the Cease-Fire...

As the owner of a Trans Am with the Cease-Fire fuel injection system I can definitely say stay away from Corvettes with that setup. It has a lot of quirks! The first few years of the Tuned Port fuel...
Forum: 70-73 Firebird & TA TECH 12-29-2013, 12:00 AM
Replies: 14
Views: 753
Posted By Dens71TA
There's something you don't see every day - bullet hole!

After stripping the doors on my '71 Trans Am we found a bullet hole and two ricochet hits on the driver's door! Past life as a getaway car? When I bought the car in 2000 it still had all the...
Forum: 70-73 Firebird & TA TECH 12-26-2013, 11:25 PM
Replies: 15
Views: 865
Posted By Dens71TA
'72 would have the variable ratio box which was...

'72 would have the variable ratio box which was the quick steering box for the time but not as quick as the later fixed ratio WS6 14:1 and 12.7:1 boxes. Its been so long[4 years) since I've driven...
Forum: 70-73 Firebird & TA TECH 12-21-2013, 10:44 PM
Replies: 16
Views: 750
Posted By Dens71TA
Here is the black/red interior. ...

Here is the black/red interior.

http://www.fossilcars.com/images/2013/06/15/337169/337169-7-lg.jpg
Forum: 70-73 Firebird & TA TECH 12-21-2013, 09:30 PM
Replies: 16
Views: 750
Posted By Dens71TA
The majority of all interior trim was molded in...

The majority of all interior trim was molded in color. Metal trim was painted. Parts shortages in a certain color may have also resulted in some painted plastics but this isn't very common.

The...
Forum: 70-73 Firebird & TA TECH 12-17-2013, 01:47 AM
Replies: 1
Views: 879
Posted By Dens71TA
Service Manual specs out 85 ft. lbs. for the four...

Service Manual specs out 85 ft. lbs. for the four body to frame bolts and 35 ft. lbs. for the radiator support. New GM subframe bolts that I have purchased over a decade ago had a stripe of loctite...
Forum: 70-73 Firebird & TA TECH 11-16-2013, 09:54 PM
Replies: 59
Views: 3,502
Posted By Dens71TA
I have repaired some of these exploding buckets...

I have repaired some of these exploding buckets with gray 2-part 3M epoxy. Did some well over a decade ago and haven't had a problem since.
Forum: THE LOBBY 11-11-2013, 02:45 AM
Replies: 10,156
Views: 1,677,934
Posted By Dens71TA
1971 Chevrolet Trans Am. It must be as rare as...

1971 Chevrolet Trans Am. It must be as rare as the Pontiac Camaro.

http://chicago.craigslist.org/nwc/ctd/4128824455.html
Forum: 70-73 Firebird & TA TECH 11-10-2013, 01:04 PM
Replies: 10
Views: 1,117
Posted By Dens71TA
Does this car have a heater core valve on the...

Does this car have a heater core valve on the inner fender that one of the heater hoses connects to? If that stays closed it will prevent the coolant from flowing through the heater core.
Forum: THE LOBBY 11-06-2013, 02:42 AM
Replies: 10,156
Views: 1,677,934
Posted By Dens71TA
Craigslist ad for some snow plows but check out...

Craigslist ad for some snow plows but check out whats in the background of the last picture. A very dirty and barn fresh '70 or 71 GTO Judge.

http://madison.craigslist.org/pts/4144853359.html
Showing results 1 to 25 of 28

 
Forum Jump

All times are GMT -4. The time now is 10:10 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017