Showing results 1 to 25 of 500
Search took 2.74 seconds.
Search: Posts Made By:
Forum: Pontiac - Street Today, 03:17 AM
Replies: 12
Views: 939
Posted By gto4ben
The hold-off is there in the combination valve....

The hold-off is there in the combination valve. Once cleaned, the GM version works very well.
Forum: Pontiac - Race Today, 12:17 AM
Replies: 26
Views: 1,524
Posted By Jay S
Also, I don’t think it was mentioned, but if you...

Also, I don’t think it was mentioned, but if you are using Ethanol, it can lift Splash Zone, Moroso a&b, or JBweld. For E15, and even E10, they need covered with a urethane paint to protect them. ...
Forum: 70-73 Firebird & TA TECH Yesterday, 10:21 PM
Replies: 1
Views: 49
Posted By 65 Lamnas
If it were me, and considering the engine harness...

If it were me, and considering the engine harness is likely original, which puts it at >50years old....I think I'd just buy a new engine harness.
Forum: THE LOBBY Yesterday, 08:39 PM
Replies: 1
Views: 75
Posted By indymanjoe
I would join a local car club and ask around as...

I would join a local car club and ask around as you may find someone who is highly recommended but not internet active.
Forum: Pontiac - Race Yesterday, 05:41 PM
Replies: 26
Views: 1,524
Posted By indymanjoe
all good points hopefully someone can use this...

all good points hopefully someone can use this info in the future! Thanks all for commenting with solutions.
Forum: THE LOBBY Yesterday, 05:25 PM
Replies: 1
Views: 76
Posted By kingbuzzo
Cultural impact of the Bandit & mullet man's Y/O Bandit review...

Never seen this before...too bad chevyed

https://youtu.be/CqLNlaj_7YY?si=JfMAIP_hdSoVEYSt
...
Forum: Ames Customer Satisfaction Forum Yesterday, 02:46 PM
Replies: 15
Views: 774
Posted By mgarblik
I just thought I would mention that the original...

I just thought I would mention that the original catalog I ordered on April 5, 2024, came today. So it took 1 month and 2 days to get here. That's some third world delivery service by the USPS. ...
Forum: Pontiac - Race Yesterday, 02:05 PM
Replies: 5
Views: 140
Posted By 461-69bird
Okay thank you, I too am using 10/30 and run...

Okay thank you, I too am using 10/30 and run similar times to you.
Forum: Pontiac - Street Yesterday, 01:15 PM
Replies: 17
Views: 331
Posted By vertigto
I was told not to mix ethanol and ethanol free...

I was told not to mix ethanol and ethanol free fuel...something about gumming things up? I assume that's BS??

Here...
Forum: Pontiac - Street Yesterday, 12:07 PM
Replies: 8
Views: 209
Posted By JLMounce
With a TBI setup like a sniper, run the manifold...

With a TBI setup like a sniper, run the manifold that you would run with a carb.

I do have back to back testing on a dual plane and single plane with my FiTech. It being first on an Edelbrock...
Forum: 69-71 Judges only TECH Yesterday, 11:13 AM
Replies: 0
Views: 88
Posted By axle
WANTED - Calling all Judges

Hello Judge owners,

I am reaching out to you because I am not only organizing the largest Indoor Display of GTO's at the Goodguys Columbus, Ohio Nationals , but the plan is to line up the entire...
Forum: Exhaust TECH Yesterday, 11:09 AM
Replies: 6
Views: 225
Posted By Formulajones
I use those band clamps all the time building...

I use those band clamps all the time building exhaust systems, however I never tried the summit brand. I always run up to Napa and buy them. Always work as advertised.
Forum: 70-73 Firebird & TA TECH Yesterday, 09:17 AM
Replies: 23
Views: 1,213
Posted By unruhjonny
that black “wire” is the lead to get lighting to...

that black “wire” is the lead to get lighting to the ashtray.
Forum: Pontiac - Street Yesterday, 07:41 AM
Replies: 17
Views: 331
Posted By Formulajones
Yep Ive found making things just a pinch richer...

Yep Ive found making things just a pinch richer makes the engine happier and doesn't affect mpg anyway.

We really don't need those factory lean calibrations, even with real fuel. Especially if...
Forum: 70-73 Firebird & TA TECH Yesterday, 07:39 AM
Replies: 23
Views: 1,213
Posted By MDSHARK81
So, after speaking with Redline Gauge Works I’ve...

So, after speaking with Redline Gauge Works I’ve decided to have them repair my original cluster ( tach/clock). Thanks Ramair. I removed the unit after dropping the column. My question is upon taking...
Forum: Pontiac - Street Yesterday, 06:59 AM
Replies: 10
Views: 428
Posted By Cliff R
In a perfect World it does NOT matter how much...

In a perfect World it does NOT matter how much pre-load you give a hydraulic lifter as long as it falls somewhere in the range of the plunger travel.

So in theory you could set them to zero...
Forum: Pontiac - Race Yesterday, 06:45 AM
Replies: 26
Views: 1,524
Posted By GTO-relic
epoxy should never be used against a water jacket...

epoxy should never be used against a water jacket or in an exhaust port, period.
it won't hold up.
only for pushrod guide holes, head bolt holes, or breakthroughs into crankcase pressure area. ...
Forum: Pontiac - Street Yesterday, 06:39 AM
Replies: 4
Views: 204
Posted By Cliff R
Transtar Industries gobbled up most of the market...

Transtar Industries gobbled up most of the market in recent years. I used them way back when I still did transmission builds in the shop and never had any issues with their stock replacement...
Forum: 70-73 Firebird & TA TECH Yesterday, 05:29 AM
Replies: 5,650
Views: 669,003
Posted By bluebird455
SD cam value

What would you guys say an NOS cam is worth.
just wondering, don't see them come up for sale anymore, unlike rods and SR carbs.
Also, K172 intake taken off a fairly low miles SD in the late 70's.
...
Forum: Pontiac - Street 05-06-2024, 11:31 PM
Replies: 4
Views: 204
Posted By Jay S
I don’t know if it will save you any money. But...

I don’t know if it will save you any money. But Dacco is what we have used and have not had any trouble with remans. I think they are the largest converter company in the country. I have one...
Forum: THE LOBBY 05-06-2024, 11:14 PM
Replies: 5
Views: 218
Posted By 'ol Pinion head
433, Hope you & yours made it through safe &...

433, Hope you & yours made it through safe & sound!

We've had a crazy storm out straight west of us, (N of 77 Trashcan's) tracking staight east for the last 2 hours (weird!). had a lot of...
Forum: Pontiac - Street 05-06-2024, 07:36 PM
Replies: 50
Views: 1,889
Posted By Skip Fix
Maybe HR lifters? Just checked a friend's new 455...

Maybe HR lifters? Just checked a friend's new 455 with RAIV heads with then new Comp HR cartridge and they are 8.70. Yes a big dish!
Forum: THE LOBBY 05-06-2024, 07:12 PM
Replies: 5
Views: 218
Posted By BILL BOWMAN1
Be safe, don’t take any chances! Mother Nature is...

Be safe, don’t take any chances! Mother Nature is a bitch .
Forum: THE LOBBY 05-06-2024, 05:39 PM
Replies: 5
Views: 218
Posted By 77 TRASHCAN
Praying for favorable weather!!!

Weather man is warning us to be aware this evening, tonight high chances for wacky weather.
I'm praying against it!!!
Forum: Pontiac - Street 05-06-2024, 05:08 PM
Replies: 17
Views: 331
Posted By Formulajones
Pretty much how I tune all my cars since I drive...

Pretty much how I tune all my cars since I drive them everywhere.
Stoich for 10 percent ethanol is 14:1
So basically what I do is tune them a bit rich on real gas and then don't worry about it, or...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 06:37 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017