Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Showing results 1 to 6 of 6
Search took 0.02 seconds. Search: Posts Made By: 68 BlueBird
Forum: 67-69 Firebird TECH 02-16-2022, 01:49 PM
Replies: 5
Views: 1,237
Posted By punkin
I'm in a similar situation where I'm putting in...

I'm in a similar situation where I'm putting in an IAII and 4l80e. My motor is aluminum so I'm expecting the front to come up a little.

My 68 originally had a 350 motor and a ST300 trans stock....
Forum: 67-69 Firebird TECH 02-16-2022, 10:13 AM
Replies: 5
Views: 1,237
Posted By JLBIII
I went with Eaton springs. Their tech was most...

I went with Eaton springs. Their tech was most helpful on what springs I should run. Installed their rear leaf springs last summer on my FB. Front end is apart right now and have a matching set of...
Forum: Pontiac - Street 10-06-2021, 07:55 PM
Replies: 56
Views: 13,834
Posted By Jonsey
Got the engine back together a couple weeks back....

Got the engine back together a couple weeks back.

We tested all the new lifters before installation. Interestingly, they had some variation in how far the plunger would travel.

Before...
Forum: Pontiac - Street 09-30-2021, 02:44 PM
Replies: 7
Views: 1,040
Posted By AIR RAM
Give Herb a call at Luhn performance and ask him...

Give Herb a call at Luhn performance and ask him about their head gaskets. They have their own Cometic 5 layer gaskets made specifically to their specs. From what he was telling me, their head...
Forum: Pontiac - Street 09-30-2021, 02:30 PM
Replies: 7
Views: 1,040
Posted By TransAm 474
I would probably go with the Cometic, along with...

I would probably go with the Cometic, along with a light coat of copper spray before installation. We have used the Titan gasket in the past on our drag radial car with a small block chevy and an F2...
Forum: Pontiac - Street 09-14-2021, 04:01 PM
Replies: 56
Views: 13,834
Posted By Jonsey
Yes, the pushrods were straight, as far as I...

Yes, the pushrods were straight, as far as I could tell. Rockers have small marks in the anodized coating where they were installed incorrectly but don't seem damaged.

I was able to get...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 06:46 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017