Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 4 1 23 Last »
Showing results 1 to 25 of 83
Search took 0.01 seconds. Search: Posts Made By: gto4ben
Forum: Heating & Cooling TECH 09-06-2024, 11:46 AM
Replies: 46
Views: 1,484
Posted By gto4ben
My definition of "rebuilt" is changing the seals,...

My definition of "rebuilt" is changing the seals, upgrading the shaft seal to double lip type, and if required, the clutch, clutch bearing, and clutch coil. "Remanufactured" to me means taking the...
Forum: THE LOBBY 09-05-2024, 11:20 PM
Replies: 845
Views: 86,200
Posted By gto4ben
I built a harmonic balancer spanner wrench for...

I built a harmonic balancer spanner wrench for the two piece version so I can remove and install the crankshaft hub bolt from the front of the car. I used a 1" angle iron from an old bed frame bent...
Forum: THE LOBBY 09-01-2024, 05:42 PM
Replies: 16
Views: 704
Posted By gto4ben
I kept my '67 GTO AC system all original using...

I kept my '67 GTO AC system all original using R12 and mineral oil. Each component was checked and bench tested for operation, pressure and vacuum leaks. I used the HNBR (hydrogenated nitric...
Forum: Heating & Cooling TECH 08-30-2024, 12:14 PM
Replies: 46
Views: 1,484
Posted By gto4ben
FWIW, the AC hose clamps 3840818 (3909030) need...

FWIW, the AC hose clamps 3840818 (3909030) need the correct torque to get the hose to seal well. 30-40 lb-in.
Forum: 66-67 GTO Tempest & LeMans TECH 08-23-2024, 02:30 PM
Replies: 6
Views: 351
Posted By gto4ben
These are California 326HO Air cleaners. The...

These are California 326HO Air cleaners. The cleaner one is towards the glossy side.
Forum: 66-67 GTO Tempest & LeMans TECH 07-11-2024, 11:44 AM
Replies: 10
Views: 634
Posted By gto4ben
Better

Better
Forum: 66-67 GTO Tempest & LeMans TECH 07-10-2024, 09:24 PM
Replies: 10
Views: 634
Posted By gto4ben
from the assembly manual

from the assembly manual
Forum: 64-65 GTO Tempest & LeMans TECH 07-06-2024, 04:31 PM
Replies: 2
Views: 329
Posted By gto4ben
This should help cross reference to Delco.

This should help cross reference to Delco.
Forum: 77-81 Firebird & Trans Am TECH 07-04-2024, 01:38 PM
Replies: 4
Views: 582
Posted By gto4ben
This source...

This source (https://www.z28.net/2012/06/08/a212cw-air-filter-headache-somewhat-resolved/) said that the "W" originally stood for oil wetted and later stood for white.
Forum: Suspension TECH 06-21-2024, 01:28 AM
Replies: 21
Views: 2,935
Posted By gto4ben
7809232...

7809232 (https://oldsobsolete.com/products-page/chevy-parts-for-sale/1971-chevrolet-parts-for-sale/1970-1984-general-motors-nos-power-steering-pump-oil-flow-control-valve-gm-7809232/) You can use a...
Forum: 66-67 GTO Tempest & LeMans TECH 06-08-2024, 12:59 AM
Replies: 6
Views: 811
Posted By gto4ben
I found that a power steering pressure gauge/flow...

I found that a power steering pressure gauge/flow gauge is very useful to diagnose a power steering problem. There are three main components of the PS system: pump, box, & hoses. The pressure gauge...
Forum: 70-72 GTO Tempest & LeMans TECH 06-06-2024, 07:18 PM
Replies: 8
Views: 1,879
Posted By gto4ben
The Delco T400 stereo tape player for the 1970...

The Delco T400 stereo tape player for the 1970 model year Pontiac , Grand Prix, Tempest, & Firebird is 02BT411 and takes two belts. The belt part number is 7304589 and is used on all the T400s....
Forum: Pontiac - Street 05-30-2024, 12:20 PM
Replies: 9
Views: 695
Posted By gto4ben
This is what I did to accommodate a 200-4R TV...

This is what I did to accommodate a 200-4R TV cable behind a 1972 manifold in my '67 LeMans. I had to weld the TV cable flanges to the existing throttle cable bracket and quadrajet throttle arm but...
Forum: Pontiac - Street 05-08-2024, 03:17 AM
Replies: 16
Views: 2,115
Posted By gto4ben
The hold-off is there in the combination valve....

The hold-off is there in the combination valve. Once cleaned, the GM version works very well.
Forum: The Body Shop TECH 04-14-2024, 12:10 PM
Replies: 2
Views: 763
Posted By gto4ben
When new, the factory installed 3 shims initially...

When new, the factory installed 3 shims initially and added or removed as needed. They must have used a gauge to determine the correct height. when I replaced my body and core support bushings. I...
Forum: Pontiac - Street 04-13-2024, 02:27 AM
Replies: 6
Views: 1,297
Posted By gto4ben
I got tired of guessing what performance the...

I got tired of guessing what performance the commercially available PP springs have so I created a spreadsheet that takes free length, outer dia., coil count, and wire diameter to calculate the...
Forum: Electrical Tech 03-25-2024, 04:53 PM
Replies: 13
Views: 1,523
Posted By gto4ben
Received the rheostat controllable LEDs today....

Received the rheostat controllable LEDs today. Their brightness are indeed controllable by voltage. The BA9S shown cuts out at ~7.5V while the dimmable version continues to light down to just under...
Forum: Electrical Tech 03-25-2024, 02:30 PM
Replies: 13
Views: 1,523
Posted By gto4ben
Here's a side by side comparison of GE 1895...

Here's a side by side comparison of GE 1895 incandescent bulb with the BA9S LED lit with 14V. What you see reflected on the instrument face depends on the background color. The LED enhances the blue...
Forum: Electrical Tech 03-24-2024, 11:14 PM
Replies: 13
Views: 1,523
Posted By gto4ben
Here are the comparisons. The cell phone camera...

Here are the comparisons. The cell phone camera sets the white balance automatically and that makes the incandescent appearance look whiter. Also, The Instrument cluster lens needs some cleaning on...
Forum: Electrical Tech 03-24-2024, 03:59 PM
Replies: 13
Views: 1,523
Posted By gto4ben
My GTO has incandescent bulbs and my LeMans has...

My GTO has incandescent bulbs and my LeMans has LEDs. I'll send you an A-B compare photos tonight. My only complaint is that the dimmer switch will not work correctly with LEDs unless you convert it...
Forum: Members Helping Members 03-23-2024, 10:37 PM
Replies: 1
Views: 686
Posted By gto4ben
1955 Delco Remy Car Application Index says...

1955 Delco Remy Car Application Index says 1102711 is used in 1950.
Forum: THE LOBBY 03-19-2024, 12:04 AM
Replies: 29
Views: 2,370
Posted By gto4ben
I had a rattler in Phoenix Arizona at a...

I had a rattler in Phoenix Arizona at a restaurant called Ruster's Rooste (https://www.rustlersrooste.com/menus/). It tasted like chicken.
Forum: Pontiac - Street 03-16-2024, 02:00 AM
Replies: 20
Views: 1,011
Posted By gto4ben
Carburetors and intake manifolds by ...

Carburetors and intake manifolds
by
Vizard, David 1996, page 87
Forum: 66-67 GTO Tempest & LeMans TECH 03-13-2024, 10:19 PM
Replies: 2
Views: 559
Posted By gto4ben
Try the Assembly Manual.

Try the Assembly Manual.
Forum: 69-71 Judges only TECH 03-09-2024, 04:07 AM
Replies: 4
Views: 1,094
Posted By gto4ben
The 71 and 72 Pontiac shop manuals do not have...

The 71 and 72 Pontiac shop manuals do not have the master cylinder codes listed like the previous years. If the '71-'72 application requires the power disc Delco-Moraine master cylinder, the Pontiac...
Showing results 1 to 25 of 83
Page 1 of 4 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 09:00 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017