Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 2.83 seconds. Search: Posts Made By:
Forum: Electrical Tech Today, 11:49 AM
Replies: 5
Views: 105
Posted By Peter Serio
Back-up lamp switch= Muncie 4 speed transmission

Here is a jpeg from a long time ago. This is a 66 GTO 4 speed transmission but a 65 GTO would be the same as far as that reverse lamp switch and wiring goes.


Where the twin wires pass thru the...
Forum: Pontiac - Street Today, 11:33 AM
Replies: 13
Views: 250
Posted By nalvarez
Im pretty sure they are 25's. Here is a picture. ...

Im pretty sure they are 25's. Here is a picture.

Pic (https://photos.app.goo.gl/h9JJJ7qDJzCnqQXR8)
Forum: Pontiac - Street Today, 10:06 AM
Replies: 25
Views: 549
Posted By HWYSTR455
Just to say, gapless rings are junk IMO. I've...

Just to say, gapless rings are junk IMO. I've seen many have issues with them. Blowby being one of them. They can 'stick' together and not compress right and wear fast. I think they are more of a...
Forum: OHC-6 TECH Today, 06:40 AM
Replies: 5
Views: 111
Posted By 455 pontiac
Gettysburg

Gettysburg
Forum: 66-67 GTO Tempest & LeMans TECH Today, 01:00 AM
Replies: 6
Views: 102
Posted By 65 Lamnas
If you're working on a traditional Pontiac V-8,...

If you're working on a traditional Pontiac V-8, I'm guessing you meant CV679C....?
Forum: Pontiac - Street Yesterday, 11:03 PM
Replies: 25
Views: 549
Posted By Tim Corcoran
I have to ask, did you use the same machinist...

I have to ask, did you use the same machinist each time you rebuilt the engine? Gapless rings are a little finicky I know I have used them in the past. They need a special finish to work correctly....
Forum: Pontiac - Street Yesterday, 10:25 PM
Replies: 25
Views: 549
Posted By pippintook
When I had blowby , I think I took an old pcv...

When I had blowby , I think I took an old pcv valve and just cut out the middle (so valve was mostly open), this did not make much of a difference in the high rpm blowby. So, I generally just ran a...
Forum: Pontiac - Street Yesterday, 08:41 PM
Replies: 25
Views: 549
Posted By Verdoro 68
Seems like you’re on the right track with lack of...

Seems like you’re on the right track with lack of crankcase ventilation. If you’re going to keep buying and trying PCV valves, consider the ME Wagner. It’s not cheap, but it will for sure do the...
Forum: Pontiac - Street Yesterday, 06:02 PM
Replies: 25
Views: 549
Posted By pippintook
Hey Rich I think for sure the rubber plug...

Hey Rich

I think for sure the rubber plug should be cut so crankcase blowby gas can escape at higher rpm. Hopefully, that is what is causing the issue.
.
I think you will find there are some...
Forum: 61-77 GTO LeMans & Tempests FOR SALE Yesterday, 05:00 PM
Replies: 7
Views: 267
Posted By 67drake
Fixed it

Fixed it
Forum: THE LOBBY Yesterday, 04:04 PM
Replies: 25
Views: 444
Posted By Lightfoot
That's what I thought I was seeing. When men were...

That's what I thought I was seeing. When men were men.
Curious about the refrigerators spaced along the wall down the front stretch. I wonder if they where for cold drinking water for the drivers,...
Forum: Pontiac - Street Yesterday, 03:27 PM
Replies: 13
Views: 250
Posted By tooski
I have a 4779 on a 400, and a demon 825 on a 461....

I have a 4779 on a 400, and a demon 825 on a 461. Neither has a choke tower. Both engines start just fine, but require a bit of throttle feathering for a minute or so until the engine develops a bit...
Forum: Pontiac - Street Yesterday, 01:32 PM
Replies: 5
Views: 180
Posted By Verdoro 68
I reused mine. I figure as long as it's tight,...

I reused mine. I figure as long as it's tight, its doing it's job.
Forum: Pontiac - Street Yesterday, 12:56 PM
Replies: 5
Views: 180
Posted By 72projectbird
I always have. Never had an issue.

I always have. Never had an issue.
Forum: Pontiac - Street Yesterday, 12:45 PM
Replies: 25
Views: 549
Posted By mgarblik
There are only 2 things that can make the...

There are only 2 things that can make the dipstick pop up. One is physical contact with the stick for some reason. You should see witness marks on the bottom of the stick somewhere or a bent stick....
Forum: OHC-6 TECH Yesterday, 12:38 PM
Replies: 5
Views: 111
Posted By TheSilverBuick
IMO, Complete, 1bbl engine, ~$250. While...

IMO, Complete, 1bbl engine, ~$250. While rare'ish, demand is also low.
Forum: Pontiac - Street Yesterday, 12:31 PM
Replies: 8
Views: 446
Posted By scott70
My 70 qjet (reworked by cliff) made around 3-4 hp...

My 70 qjet (reworked by cliff) made around 3-4 hp more on the dyno than shops 850 Holley DP.

On nicks olds 455 dyno engine I was more concerned with the oil pressure dropping...
Forum: Pontiac - Street Yesterday, 11:27 AM
Replies: 5
Views: 180
Posted By steve25
If you still have to drive them in then there...

If you still have to drive them in then there good to go.
Forum: 69-71 Judges only TECH Yesterday, 11:25 AM
Replies: 6
Views: 200
Posted By Bill Eveland
My uncles, ra3 auto, ac, red interior. Original...

My uncles, ra3 auto, ac, red interior. Original owner . There was supposed to be another like this red and white swapped. 3 speed manual trans car.
Forum: Pontiac - Street Yesterday, 11:20 AM
Replies: 5
Views: 180
Posted By michaelfind
I always have reused them. I'm no expert but no...

I always have reused them. I'm no expert but no troubles yet.
Forum: Pontiac - Street Yesterday, 10:54 AM
Replies: 36
Views: 1,375
Posted By i82much
I bought the ME Wagner PCV valve and it helped...

I bought the ME Wagner PCV valve and it helped with oil leaks a fair amount. I used a cheap manometer from Amazon, and confirmed that I was getting more negative crankcase pressure at idle and...
Forum: Pontiac - Street Yesterday, 10:21 AM
Replies: 25
Views: 549
Posted By i82much
pcv shouldn't be doing anything at WOT. honestly...

pcv shouldn't be doing anything at WOT. honestly oil leaks are part of the deal with old cars, just accept it. don't nitpick your way out of the hobby!! you take a close look at ANY old car at a...
Forum: 70-73 Firebird & TA TECH Yesterday, 10:01 AM
Replies: 77
Views: 4,071
Posted By formula kid
Originally ordered my 74 Formula as an SD455 car...

Originally ordered my 74 Formula as an SD455 car with spoiler. Was Pissed that it would come with the Trans Am hood, wanted the Ram air option. I was told could not be done.
Forum: Pontiac - Street Yesterday, 10:01 AM
Replies: 87
Views: 3,254
Posted By track73
That's what New car dealers used when "cash for...

That's what New car dealers used when "cash for clunkers" was a thing.
Forum: 70-73 Firebird & TA TECH Yesterday, 09:59 AM
Replies: 40
Views: 4,256
Posted By 78w72
Just an FYI for you on the BFG warranty, it is...

Just an FYI for you on the BFG warranty, it is for 6 years so your dates should qualify under their warranty as cosmetic defects. Its worth a call if you still have the tires, if the frontline reps...
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 02:31 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017